-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueBreaking High-speed Material Constraints
Do you need specialty materials for your high-speed designs? Maybe not. Improvements in resins mean designers of high-speed boards can sometimes use traditional laminate systems. Learn more in this issue.
Level Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
Opportunities and Challenges
In this issue, our expert contributors discuss the many opportunities and challenges in the PCB design community, and what can be done to grow the numbers of PCB designers—and design instructors.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
Quiet Power: Don't Forget to Terminate Cables
We know that in high-speed signal integrity measurements, one of the first rules is to properly terminate traces and cables. However, many of our PDN measurements may be limited to lower frequencies, such as measuring the switching ripple of a DC-DC converter. Do we really need to terminate our measurement cables if the signal we want to measure is the switching ripple of a converter running at 1 MHz? We may think that termination is not needed or does not matter in this case, but we may be in for some surprises!
Let us look at the output ripple of the LTM4604 converter, which was our device under test in an earlier column. The converter is powered from a 4.5V battery pack, and its output voltage is set to 1.2V. An approximate 1A DC load is created by a small incandescent bulb. The output ripple is measured by a Tektronix TDS540B oscilloscope that I recently bought on eBay. The 1 GS/s maximum real-time sampling rate and 500 MHz analog bandwidth, together with a maximum 1 mV/div vertical sensitivity makes this category of oscilloscopes very useful for many PDN measurements even today. Read the full column here.Editor's Note: This column originally appeared in the August 2013 issue of The PCB Design Magazine.
More Columns from Quiet Power
Quiet Power: The Effect on SI and PI Board PerformanceQuiet Power: 3D Effects in Power Distribution Networks
Quiet Power: Noise Mitigation in Power Planes
Quiet Power: Uncompensated DC Drop in Power Distribution Networks
Quiet Power: Ask the Experts—PDN Filters
Quiet Power: Friends and Enemies in Power Distribution
Quiet Power: Be Aware of Default Values in Circuit Simulators
Quiet Power: Do You Really Need That Ferrite Bead in the PDN?