Molex Solder on Polyester Substrate Delivers Flexible, Cost-effective Circuitry


Reading time ( words)

Molex has introduced Solder on Polyester Substrate, a flexible, economical alternative to rigid PCB and polyimide. Surface mount (SMT) components, including fine-pitched integrated circuits (ICs) are attached with low-temperature solder and encapsulated on a polyester substrate. Custom designed products can be used for capacitive touch buttons, capacitive fluid level sensors and membrane switches in a broad range of consumer, medical and industrial applications.

“The ability to bond fine-pitch ICs to polyester film using traditional SMT processes can free up real estate on the controller PCB,” said Steve Fulton, engineering manager, Molex. “Before Molex developed this flexible circuit solution, ICs couldn’t be soldered to PET because the high-temperature process would damage the polyester. The alternative, conductive epoxy, can cause short circuits between closely spaced contacts, limiting component sizes and packages.” 

By allowing smaller components with tighter pitches, the Solder on Polyester Substrate delivers higher yields and reduces costs. To ensure a robust connection, solder joints are protected by UV-cured encapsulant, enabling them to withstand vibration and mechanical shock. In addition, right-angle LEDs can be attached to enhance backlighting for user-interface applications. The flexible substrate is available in clear, translucent or white. Typical thicknesses are 0.13 and 0.18mm. 

About Molex 

Molex brings together innovation and technology to deliver electronic solutions to customers worldwide. With a presence in more than 40 countries, Molex offers a full suite of solutions and services for many markets, including data communications, consumer electronics, industrial, automotive, commercial vehicle and medical.

Share

Print


Suggested Items

PCB Surface Preparation Before Solder Mask on Non-copper Finishes

04/08/2020 | Nikolaus Schubkegel
A circuit board is made of copper. Usually, final finishes are applied after the solder mask process. In some cases, for special applications, the final finish may be applied before solder mask. In this case, we have solder mask on ENIG or galvanic nickel-gold. It is also possible to have tin or tin-lead under solder mask; this was an old technology that no longer plays a role today.

The Direction of MacDermid Alpha’s Automotive Initiative

04/02/2020 | Nolan Johnson, I-Connect007
Nolan Johnson speaks with Lenora Clark about MacDermid Alpha’s automotive initiative, where her role fits into the company’s focus on supporting carmakers in various business areas, and where the future of automotive is heading.

Institute of Circuit Technology Spring Seminar 2020

03/11/2020 | Pete Starkey, I-Connect007
Back to Meriden, the nominal centre of England where the daffodils were blooming. A good crowd made it to the spring seminar that followed the Annual General Meeting of the Institute of Circuit Technology (ICT), with five specialist presentations and excellent opportunities to network with their peers in the industry. Pete Starkey shares his overview of the event.



Copyright © 2020 I-Connect007. All rights reserved.