CyberOptics to Showcase 3D AOI Systems at IPC APEX EXPO 2017


Reading time ( words)

CyberOptics Corporation will exhibit at the 2017 IPC APEX EXPO, scheduled to take February 14-16, 2017 at the San Diego Convention Center in California. The MRS-enabled SQ3000 3D Automated Optical Inspection (AOI) system, deemed best-in-class, will be on display for live demonstrations, along with the MRS-enabled CyberGage 360 and the QX250i. CyberOptics will be in Booth 2809.

The SQ3000 3D AOI system maximizes ROI and line utilization with multi-view 3D sensors that capture and transmit data simultaneously, and in parallel, accelerating 3D inspection speed versus alternate technology. The proprietary Multi-Reflection Suppression (MRS) technology combined with the highly sophisticated 3D fusing algorithms offers microscopic image quality at production speeds.

The CyberGage360 presents an unprecedented combination of speed, accuracy and one-button simplicity for non-contact automated 3D scanning inspection. The system dramatically speeds up quality assurance of in-process inspection and/or incoming/outgoing parts inspection; lowers cost of quality and speeds up product time-to-market. Designed for use in general purpose metrology, the CyberGage360 has a range of potential industrial applications from automotive to aerospace to consumer electronics, where high accuracy and high speed throughput are important.

The QX250i simultaneous double-sided AOI system offers fast, flexible and high performance inspection for all applications, and is ideally suited for pre-reflow and selective solder inspection. The top and bottom high-resolution Strobed Inspection Modules (SIMs) with enhanced illumination provide a single platform for the inspection and defect review process that shortens the production line and drives approximately 50 percent productivity improvement.

About CyberOptics

CyberOptics Corporation (www.cyberoptics.com) is a leading global developer and manufacturer of high precision sensing technology solutions. CyberOptics’ sensors are used in general purpose metrology and 3D scanning, surface mount technology (SMT) and semiconductor markets to significantly improve yields and productivity. By leveraging its leading edge technologies, the company has strategically established itself as a global leader in high precision 3D sensors, allowing CyberOptics to further increase its penetration of key vertical segments. Headquartered in Minneapolis, Minnesota, CyberOptics conducts worldwide operations through its facilities in North America, Asia and Europe.

Share

Print


Suggested Items

Excerpt: The Printed Circuit Assembler’s Guide to... SMT Inspection: Today, Tomorrow, and Beyond, Chapter 1

04/08/2021 | Brent Fischthal, Koh Young America
Today, optical inspection systems are the preferred solution for in-line quality control in the SMT industry. Systems such as solder paste inspection (SPI) or automated optical inspection (AOI) systems for pre- and post-reflow are almost standard in every production facility.

Real Time With… Premium Sponsors Share ‘Top 5 Things You Need to Know’

03/05/2021 | I-Connect007
As part of I-Connect007’s coverage of the IPC APEX EXPO 2021, four premium sponsors share their knowledge and expertise in the following categories.

What Makes a Good Process Engineer?

03/03/2021 | Nolan Johnson, I-Connect007
Nolan Johnson recently spoke with Tuan Tran, director of customer solutions at Green Circuits, about what makes a successful process engineer. They also discuss a typical day in the life of a process engineer—from pre-manufacturing through post-DFM, for process improvement. As Tuan points out, there are a variety of paths to becoming a great process engineer.



Copyright © 2021 I-Connect007. All rights reserved.