RTW IPC APEX EXPO: KIC on Smart Factory Technology Approach in Thermal Ovens


Reading time ( words)

Bjorn Dahle, president of KIC Thermal, discusses with I-Connect007 Guest Editor Dick Crowe their approach to measuring temperatures in thermal ovens and networking the information to a main frame, to enable the process engineer to statistically monitor a specific process.

Watch The Interview Here

Share


Suggested Items

Video from productronica 2017: Koh Young Focuses on Total Inspection Solution

11/20/2017 | I-Connect007
At the show floor of productronica 2017, I-Connect007 Technical Editor Pete Starkey speaks with Managing Director Harald Eppinger of Koh Young Europe GmbH about the principles of Koh Young’s total 3D inspection solution for SMT process optimization and yield improvement.

How to Make a Bad First Impression with an EMS Provider

06/15/2017 | Neil Sharp, JJS Manufacturing
Like any relationship, starting off on the wrong foot when finding an EMS provider can quickly trip you up and become painful in the long term. Regardless of the 'why', here are some good examples of what not to do when first approaching a potential EMS provider. This way, you can make sure that you don't end up wasting valuable time and effort finding the wrong EMS provider for your business.

2D X-ray Inspection With Materials and Thickness Identification

06/07/2017 | Paul D. Scott, Ph.D., IBEX Innovations, and Evstatin Krastev, Ph.D., P.E., Nordson Dage
The need to inspect electronic components and assemblies non-destructively is the main driver behind the development of X-ray inspection technology. In many cases, X-ray inspection provides the only non-destructive techniques to inspect optically hidden components and solder joints such as BGA, POP, QFN, flip chips, through-holes, TSVs, microbumps, and copper pillars.



Copyright © 2017 I-Connect007. All rights reserved.