RTW IPC APEX EXPO: Alpha Highlights Technologies Dedicated to Eliminating Solder Voids


Reading time ( words)

Robert Wallace, marketing manager for Americas, at Alpha Assembly Solutions, discusses with I-Connect007 Guest Editor Dick Crowe their new product introductions for this year and their level of customer support as these products are rolled out. He also talks about how these technologies are helping address the issue on solder voiding.

Watch The Interview Here

Share


Suggested Items

PCB Pad Repair Techniques

01/08/2018 | Bob Wettermann, BEST Inc.
There are a variety of reasons behind pads getting "lifted" completely or partially from the laminate of a PCB. Per the just revised IPC-A-610 Revision G, a defect for all three classes occurs when the land is lifted up one or more pad thicknesses. Lifted pads can occur when a device has been improperly removed or there is a manufacturing defect in the board construction. In any case, as with any repair, the ultimate decision on the ability to repair the pad lies with the customer.

Top 10 Most-Read SMT007 Columns of 2017

01/02/2018 | I-Connect007
Another year is over in the SMT industry. 2017 saw a myriad of hot topics, including Industry 4.0, the millennials’ entry into the manufacturing space, and alternative solder materials, to name a few. Without further ado, here are the Top 10 columns from SMT007 over the past year.

The Effect of Area Shape and Area Ratio on Solder Paste Printing Performance

12/28/2017 | Stefan Härter, et al.
The ongoing miniaturization trend in the SMT production induces new challenges and highly integrated systems. In passive components, the miniaturization leads to the introduction of the EIA size 01005 or smaller. Despite numerous publications in this field already addressing the printing of such devices, a defined wholly optimized process remains unsolved and inspires further novel research ideas on this topic.



Copyright © 2018 I-Connect007. All rights reserved.