EMS Solutions Chooses Aqua Klean for State-of-the-Art Cleaning


Reading time ( words)

Utah-based EMS Solutions has placed an order for Aqua Klean Systems' T-12 Water Soluble Cleaner and DI Recirculating System during the recent IPC APEX EXPO. EMS Solutions is a premier regional EMS provider specializing in printed circuit board assemblies (PCBAs) for SMT and thru hole, RoHS and non-RoHS manufacturing, IPC-A-610 II & III manufacturing standards, harness and cable assemblies, and more. 

EMS Solutions currently runs four SMT lines. The company’s equipment includes state-of-the-art, high-speed, efficient lines that provide consistent high quality products. All SMT lines are supported by AOI equipment, automated thru hole placement technology, and all other required support equipment. 

The Typhoon T-12 Water Soluble Cleaner comes standard with a 24" wide belt, the industry's safest smart heater, quick adjustable pressure valves, easy to access front valves and an innovative touchscreen software interface. Equipped with a 15 HP wash and rinse pump, and two 15 HP turbine blowers, the Typhoon T12's performance is unmatched. 

The new DI Recirculating System provides cost savings and drastically reduces water consumption. Aqua Klean DI Recirculating Systems are built with quality and durability in mind here in the USA. Every unit is quality tested in the Aqua Klean facility to ensure full and proper operation in the field. Only high quality filters, pumps, valves, and electrical components are assembled into these units. 

Aqua Klean Systems takes pride in working with customers to solve any process issues they encounter now, or into the foreseeable future. For more information about Aqua Klean Systems and the company’s wide variety of products, please visit www.aquaklean.com

Share


Suggested Items

PCB Pad Repair Techniques

01/08/2018 | Bob Wettermann, BEST Inc.
There are a variety of reasons behind pads getting "lifted" completely or partially from the laminate of a PCB. Per the just revised IPC-A-610 Revision G, a defect for all three classes occurs when the land is lifted up one or more pad thicknesses. Lifted pads can occur when a device has been improperly removed or there is a manufacturing defect in the board construction. In any case, as with any repair, the ultimate decision on the ability to repair the pad lies with the customer.

Focus on the New

01/05/2018 | Stephen Las Marias, I-Connect007
It seems like it wasn't too long ago when I was writing about the optimism of the electronics manufacturing and assembly industry going into 2017. Now, here we are again at the beginning of the new year, looking at new trends, disruptive technologies, and emerging markets for 2018. I am also proud to announce our new branding as well as our fresh, new look.

Top 10 Most-Read SMT Articles of 2017

12/29/2017 | I-Connect007
Every year, we like to take a look back at the most popular SMT news and articles. These are the top 10 most-read SMT articles from the past year.



Copyright © 2018 I-Connect007. All rights reserved.