Larry Fey Joins KIC as Principal Electrical Engineer


Reading time ( words)

KIC has appointed Larry Fey to the position of principal electrical engineer. Fey is an exceptionally skilled and accomplished electrical engineer with more than 27 years of hands-on design experience. He has been active in all phases of product development, including feasibility studies, planning, design, CAD, assembly, testing, field trials, production support and customer assistance.

Fey first started out in the industry in 1989 with Tollgrade Communications Inc. as principal engineer. He joined the company when it was a small start-up business and became an important member of the engineering department throughout its rise to a publicly traded company.

After 17 years with Tollgrade Communications, he transitioned to his role as hardware engineer at Sandel Avionics Inc. There, he was the main electrical engineer for hardware design, learning, and supporting legacy products as well as the design and development of new products for the past 10 years. Fey holds a Bachelor’s Degree in Electrical Engineering from the University of Notre Dame, and is experienced with CAD design tools, including DxDesigner, PADS PCB, and Xilinx and Altera design tools.

About KIC

Based in San Diego, KIC is the industry leader in automated thermal process tools and systems for reflow, wave, curing and semiconductor thermal processes. The company pioneered the development of oven profilers and process optimization tools, and then worked to create the next generation of thermal systems to help manufacturers improve the thermal process quality while reducing cost.

KIC products include the KIC SPS, K2, X5, KICstart2, ProBot, 24/7 Wave and the KIC RPI. With the introduction of cutting edge tools, the company continues to stay on the leading edge of process optimization and automatic thermal process systems, and has won numerous industry awards.

For more information about KIC, click here.

Share


Suggested Items

HDI Considerations: Interview with ACDi's Garret Maxson

11/10/2017 | Stephen Las Marias, I-Connect007
Garret Maxson, manager of engineering services at American Computer Development Inc. (ACDi), discusses the PCB assembly challenges when dealing with high-density interconnect (HDI) boards, parameters to consider, and strategies to help facilitate a smooth assembly process when using HDI boards.

Should I Involve My EMS Partner in DFM?

10/26/2017 | Neil Sharp, JJS Manufacturing
OEMs are seeking the support of EMS providers with more than just manufacturing, but with design elements too. One of the main design services EMS providers will be likely to offer is design for manufacture (DFM). This article highlights why engaging your EMS partner in DFM is worthwhile, and will be valuable in securing the longevity of your product.

The Root Causes & Solutions for Warped PC Boards

09/27/2017 | Duane Benson, Screaming Circuits
There are two primary types of causes of board warping: process related at the fab or assembly shop, and layout related issues. If it's warped before assembly, it's between fab and layout. If it's flat before assembly and warped after, it's most likely between layout and assembly. That said, sometimes a fab problem won't show up until a pass through the reflow oven at your assembly partner.



Copyright © 2017 I-Connect007. All rights reserved.