Seika Machinery to Showcase Latest Solder Paste Mixer at SMTAI 2017


Reading time ( words)

Seika Machinery Inc. will show the new Malcom SPS-2000 Solder Paste Mixer at SMTA International. This new version adds may new functions to make sure your paste is at its optimum condition for use.

The SPS-2000 features high-speed mixing capabilities (approx. 1000RPM), resulting in shorter mixing times. The mixer can be programmed to automatically stop at a specified mixing time or paste temperature. The system’s temperature monitoring function allows the user to verify the paste's optimum temperature.

The SPS-2000 cam program and run up to eight user-specified mixing profiles. Programs are created via connecting a PC and using the software. The built-in auto balancer function automatically counter balances a single paste jar according to the amount of paste present in the jar. The jar does not have to be full.

For more information, visit Seika Machinery in Booth #715 at SMTA International, scheduled to take place Sept. 19-20, 2017 at the Donald Stephens Convention Center in Rosemont, Illinois.

About Seika Machinery, Inc.

Seika Machinery, Inc. (SMI) is a subsidiary of Seika Corporation, Japan and member of the Mitsubishi Global Group. SMI provides electronics manufacturers with advanced machinery, superior materials and engineering services. For more information click here.

Share


Suggested Items

PCB Pad Repair Techniques

01/08/2018 | Bob Wettermann, BEST Inc.
There are a variety of reasons behind pads getting "lifted" completely or partially from the laminate of a PCB. Per the just revised IPC-A-610 Revision G, a defect for all three classes occurs when the land is lifted up one or more pad thicknesses. Lifted pads can occur when a device has been improperly removed or there is a manufacturing defect in the board construction. In any case, as with any repair, the ultimate decision on the ability to repair the pad lies with the customer.

Top 10 Most-Read SMT007 Columns of 2017

01/02/2018 | I-Connect007
Another year is over in the SMT industry. 2017 saw a myriad of hot topics, including Industry 4.0, the millennials’ entry into the manufacturing space, and alternative solder materials, to name a few. Without further ado, here are the Top 10 columns from SMT007 over the past year.

The Effect of Area Shape and Area Ratio on Solder Paste Printing Performance

12/28/2017 | Stefan Härter, et al.
The ongoing miniaturization trend in the SMT production induces new challenges and highly integrated systems. In passive components, the miniaturization leads to the introduction of the EIA size 01005 or smaller. Despite numerous publications in this field already addressing the printing of such devices, a defined wholly optimized process remains unsolved and inspires further novel research ideas on this topic.



Copyright © 2018 I-Connect007. All rights reserved.