RTW SMTAI: Mentor Eases Programming in Viscom Inspection Systems


Reading time ( words)

At the recent SMTA International 2017 exhibition, Jesper Lykke, engineering manager for USA of Viscom AG, and Zac Elliott, technical marketing engineer at Mentor, speak with I-Connect007 Managing Editor Andy Shaughnessy about Viscom's adoption of the Valor Process Preparation and how it is helping users with their inspection programming.

Watch the interview here.

Share


Suggested Items

Equipment Matters in Solder Paste Printing

12/06/2017 | Stephen Las Marias, I-Connect007
The solder paste printing process has always been considered a major contributor to yield loss. According to many studies, solder paste printing accounts for up to 70% of all PCB assembly defects. For the December issue of SMT Magazine, we interviewed experts in the solder paste printing process to learn more about the key issues leading to this huge percentage of defects, and the technology developments that are addressing these challenges and improving yields in the process.

Video from productronica 2017: Koh Young Focuses on Total Inspection Solution

11/20/2017 | I-Connect007
At the show floor of productronica 2017, I-Connect007 Technical Editor Pete Starkey speaks with Managing Director Harald Eppinger of Koh Young Europe GmbH about the principles of Koh Young’s total 3D inspection solution for SMT process optimization and yield improvement.

5 Simple Elements to Guarantee Outsourcing Success

11/09/2017 | Neil Sharp, JJS Manufacturing
Rather than viewing outsourcing as a way to offload unwanted tasks, OEMs should spend time carefully selecting and then maintaining a properly managed relationship with their chosen EMS partner. Here are five simple elements that you should focus on before, during and after an outsourcing strategy to guarantee it is a success.



Copyright © 2017 I-Connect007. All rights reserved.