Magneti Marelli Settles on TRI's PCBA Inspection Solutions


Reading time ( words)

TRI.jpgMagneti Marelli S.p.A. and Test Research, Inc. (TRI) announced a global strategic partnership. TRI is pleased to contribute for a higher quality production and honored to announce becoming part of the Approved Vendor List (AVL) for Magneti Marelli.

Jim Lin, TRI's VP of Sales and Marketing expressed for this occasion: "Magneti Marelli's success is because of their dedication to deliver high-tech and high-quality production. We are proud to contribute the quality assurance and safety that Magneti Marelli is well known for.” Test Research, Inc. assures not just quality in your PCBA line but also a ubiquitous state of the art personalized sales and customer service.

This is only possible because of TRI’s multiple branches and distributors. TRI will like to extend its gratitude to ITronik’s commitment for this partnership to happen. 

TRI has the complete PCBA Inspection solutions for achieving top-tier production line, continuously bringing high performance and high speed inspection system to provide its customers with high quality SMT production.

About TRI

TRI offers the most robust product portfolio in the industry for Automatic Test and Inspection solutions. From Solder Paste Inspection (SPI), Automated Optical Inspection (AOI), and 3D Automated X-ray Inspection (AXI) systems to Manufacturing Defect Analyzers (MDAs) and In-Circuit Test (ICT) equipment, TRI provides the most cost-effective solutions to meet a comprehensive range of manufacturing Test and Inspection requirements. For more information, click here.

Share


Suggested Items

PCB Pad Repair Techniques

01/08/2018 | Bob Wettermann, BEST Inc.
There are a variety of reasons behind pads getting "lifted" completely or partially from the laminate of a PCB. Per the just revised IPC-A-610 Revision G, a defect for all three classes occurs when the land is lifted up one or more pad thicknesses. Lifted pads can occur when a device has been improperly removed or there is a manufacturing defect in the board construction. In any case, as with any repair, the ultimate decision on the ability to repair the pad lies with the customer.

Top 10 Most-Read SMT007 Columns of 2017

01/02/2018 | I-Connect007
Another year is over in the SMT industry. 2017 saw a myriad of hot topics, including Industry 4.0, the millennials’ entry into the manufacturing space, and alternative solder materials, to name a few. Without further ado, here are the Top 10 columns from SMT007 over the past year.

The Effect of Area Shape and Area Ratio on Solder Paste Printing Performance

12/28/2017 | Stefan Härter, et al.
The ongoing miniaturization trend in the SMT production induces new challenges and highly integrated systems. In passive components, the miniaturization leads to the introduction of the EIA size 01005 or smaller. Despite numerous publications in this field already addressing the printing of such devices, a defined wholly optimized process remains unsolved and inspires further novel research ideas on this topic.



Copyright © 2018 I-Connect007. All rights reserved.