Jigar Patel to Present at SMTA West Penn Expo and Tech Forum


Reading time ( words)

ZESTRON is pleased to announce that Jigar Patel, M.S.Ch.E., senior application engineer, ZESTRON Americas, will present “Design for Reliability: Overcoming Present Day Challenges for Class III Assemblies” at the SMTA West Penn Expo and Tech Forum.

When designing Hi-Rel electronic assemblies, functionality is critical and long-term reliability is essential. This presentation provides an overview of the various failure mechanisms including the challenges associated with improper cleaning, board complexity, material mix, component and package types used. Case studies will be reviewed addressing steps to reduce the risk of failure and improve long term reliability. 

The SMTA West Penn Expo and Tech Forum will be held on March 28th, from 9:30 AM to 3 PM at the DoubleTree in Monroeville, PA. To register, click here

About ZESTRON

Headquartered in Manassas, Virginia, and operating in more than 35 countries, ZESTRON is the globally leading provider of high precision cleaning products, services and training solutions for the electronics and semiconductor manufacturing industries. With seven worldwide technical centers and the largest team of engineers focused on high precision cleaning, ZESTRON’s commitment to ensuring that its customers surpass even the most stringent cleaning requirements is without equal.

For additional information and to tour one of our unparalleled technical centers, please click here.

Share

Print


Suggested Items

Tips & Tricks: Water Contamination and Flux Expiry

04/17/2019 | Jason Fullerton, MacDermid Alpha Electronics Solutions
Solder joints that form properly are not expected to exhibit reduced reliability. However, a higher number of defects created tends to lead to a higher chance that defective connections escape detection through inspection and functional testing, and that’s not a risk to be taken lightly.

Which IPC-A-610 Class is Best for Your PCBA?

04/08/2019 | Neil Sharp, JJS Manufacturing
For many EMS providers, IPC-A-610 is the agreed standard to define what's acceptable and what's not in the world of PCBA production. As an OEM, it's important that you're clear on the basic principles that separate those classes so that you have a clear and realistic expectation of what the results are going to be.

Bill Cardoso Discusses Creative Electron’s Inspection Strategy

04/03/2019 | Tim Haag and Barry Matties, I-Connect007
At PCB West in Santa Clara, California, Dr. Bill Cardoso of Creative Electron held a class on advanced packaging and X-ray inspection strategy. Guest Editor Tim Haag and Publisher Barry Matties met with Bill to further discuss his class and the importance of turning inspection data into information.



Copyright © 2019 I-Connect007. All rights reserved.