Microtek Laboratories China Adds High-Tech Reflow Oven for Automotive and Transportation Reflow Simulation Testing


Reading time ( words)

Microtek is proud to announce the addition of a 13-zone, active-cooled, Heller reflow oven at its Changzhou, China facility to accomplish reflow preconditioning for test samples. Automotive and Transportation Reliability testing requires aggressive reflow preconditioning cycles prior to reliability testing that demand a 13 zone oven with active water cooling to accomplish properly. 

The new reflow oven is also equipped to use an inert nitrogen environment for reflow that protects the soldermask and surface finish from degradation due to oxidation during reflow exposure. Microtek’s commitment to Automotive and Transportation testing also includes the use of 10 thermal shock chambers equipped for "Single Hole" or "Daisy Chain" reliability testing along with 28 humidity and HAST chambers equipped with 256 channels of CAF/ECM/SIR testing capability up to 2000VDC.

About Microtek Laboratories China

Microtek Laboratories China is a leading third-party testing agency, serving the electronics and polymeric materials manufacturing industry world-wide. It is operated in accordance with the ISO/IEC17025: 2005 management system, accredited by CNAS, CMA, and many large OEM’s. The lab provides testing and conformance verification to company, national & international standards for automotive, telecommunication, aerospace & aviation, electronic information products, polymeric products and other related industries and suppliers. It is a CQC licensed lab for "Non-metal materials" including printed circuit boards (PCB), copper-clad laminates (CCL) and plastics. The lab is also designated as the product service center for CPCA, an authorized training center for IPC-6012, IPC-A-610 & IPC-A-600, as well as a IPC Validation Services Qualified Test Laboratory for IPC-6012 and IPC-4101. In addition, Microtek Laboratories China has the capability of temperature and humidity calibration as recognized by CNAS. For more information, click here.

 

Share

Print


Suggested Items

Impact of Stencil Foil Type on Solder Paste Transfer Efficiency for Laser-cut SMT Stencils (Part 1)

04/24/2019 | Greg Smith, BlueRing Stencils
As innovation and demand continue to drive miniaturization in electronics, manufacturers face the constant challenge of assembling smaller and smaller components with repeatable processes and high yields. Stencil printing is the first step in the PWB assembly process, and improvements to the SMT stencil can significantly improve yields, especially for more challenging miniaturized products.

SMTA Europe Electronics in Harsh Environments Conference 2019: A Preview

03/26/2019 | Pete Starkey, I-Connect007
As a prelude to this year's Electronics in Harsh Environments conference, which will be held on April 2–4, 2019 in Amsterdam, Netherlands, SMTA Europe chairman Keith Bryant, supported by technical specialist Bob Willis, showcased the challenges and key issues faced by design and process engineers worldwide, in a webinar entitled "Harsh Environment Failures—Causes & Cures."

Current Megatrends You Pay the Most Attention To

03/20/2019 | I-Connect007 Research Team
In our recent survey, we asked the following question: "What current megatrends do you pay the most attention to?" Below are some of the replies, edited slightly for clarity.



Copyright © 2019 I-Connect007. All rights reserved.