I-Connect007 Survey Shows Rising Use of Flex and Rigid-Flex


Reading time ( words)

In our recent survey on flex and rigid-flex circuits, majority or 76% of the respondents are currently using flex, rigid-flex and printed electronics in their manufacturing.

Of the 24% who answered no, a strong majority, 70%, are planning to use rigid-flex circuits in the future; 60% said they will use flex circuits; while 30% are also planing to use printed electronics.

chart-2.png


To learn more about the survey, and to find out about the biggest problems when it comes to flex and rigid flex circuit design, fabrication, or assembly, check out the July issue of Flex007 Magazine.

Share

Print


Suggested Items

Laserssel Brings High-speed Soldering to New Application Areas

06/10/2019 | Barry Matties, I-Connect007
In this interview with I-Connect007, Denis Barbini, general manager of Laserssel, talks about the company's new laser-selective reflow solution aimed at reducing a typical reflow oven’s 10-minute cycle down to just 10 seconds as well as the overall benefits manufacturers could see from streamlining this process.

Flex Circuit Supply Chain Challenges

02/13/2019 | Stephen Las Marias, I-Connect007
In our recent Flex and Rigid-Flex survey, we asked the following question: "Do you have problems with your flex circuit supply chain?" Below are just a few of the explanations of those who answered "Yes", slightly edited for clarity.

Top 10 Most-Read SMT Interviews of 2018

01/04/2019 | Stephen Las Marias, I-Connect007
We continue our top 10 lists, this time with the most-read SMT interviews in 2018. Topping the list is an interview with Joe O’Neil and Matthew Becker of Power Design Services (PDS), along with Ted Park of Green Circuits, who announced their merger last year.



Copyright © 2019 I-Connect007. All rights reserved.