BTU’s Fred Dimock to Present at ACI Technologies’ Open House


Reading time ( words)

BTU International, Inc. is pleased to announce that Fred Dimock, manager of Process Technology, will present at ACI Technologies’ Open House. The event will take place on Tuesday, September 25, 2018 on ACI’s manufacturing factory floor at its facility in Philadelphia, Pennsylvania.

Dimock will present the equipment and process used to address two important reflow topics. The first will be the elimination of voids in thermal pads by using vacuum reflow, and the other is keeping flexible circuits and thin boards flat during reflow.

Dimock has assisted many companies with process refinements, and has authored numerous articles on lead free solder, process control and the operation of continuous furnaces.

Additionally, Dimock teaches numerous SMTA solder reflow classes and has participated in the 5-45 Subcommittee for the development of IPC-7801 Reflow Oven Process Control Standard. He wrote the chapter on solder reflow for the ‘Handbook of Electronic Assembly’ and ‘A Guide to SMTA Certification’ by Dr. Lasky and Jim Hall.

Dimock holds an Associate’s Degree in Mechanical Design from Wentworth in Boston and a Bachelor’s Degree in Ceramic Engineering from the State University of New York at Alfred (SUNY). He is a long-standing member of the SMTA Technical Committee.

About BTU International

BTU International, a wholly-owned subsidiary of Amtech Group, is a global supplier and technology leader of advanced thermal processing equipment and processes to the electronics manufacturing and alternative energy markets. BTU equipment is used in the production of printed circuit board assemblies and semiconductor packaging as well as in the manufacturing of solar cells and nuclear fuel. BTU has operations in North Billerica, Massachusetts, and Shanghai, China, with direct sales and service in the U.S.A., Asia and Europe. Information about BTU International is available here.

Share

Print


Suggested Items

Comparing Soldering Results of ENIG and EPIG Post-steam Exposure

09/11/2019 | Jon Bengston and Richard DePoto, Uyemura International USA
Electroless nickel immersion gold (ENIG) is now a well-regarded finish used to enhance and preserve the solderability of copper circuits. Electroless palladium immersion gold (EPIG), meanwhile, is a new surface finish also for enhancing and preserving solderability—but with the advantage of eliminating electroless nickel from the deposit layer. This feature has become increasingly important with the increasing use of high-frequency PCB designs whereby nickel’s magnetic properties are detrimental.

Solder Mask Evolves into a Truly Additive Process

09/09/2019 | John Fix, Taiyo America Inc.
The 5G era is creating quite a bit of work for many PCB engineers as the materials required to keep up with the speed, frequency, and latency requirements need to be defined and qualified. Solder mask, for example, now becomes a truly additive process. Read on to find out how and why.

Selecting the Proper Flex Coverlayer Material

09/06/2019 | Dave Lackey, American Standard Circuits
Coverlayers are polymer materials used to cover and protect the copper traces of the flex circuit product. There are a number of different options available for protecting the circuits, and they serve different design requirements in terms of cost, performance, and flexural endurance optimization. When specifying the choice, it is critical to call out not just the type of coverlayer material but also the thickness requirement. This can be very important in certain types of constructions, especially when a flex circuit will experience dynamic flexing during use.



Copyright © 2019 I-Connect007. All rights reserved.