Goepel electronic's New 3D Camera Module for Stand-Alone AOI System Basic Line


Reading time ( words)

Goepel electronic's stand-alone AOI system "Basic Line" can now be equipped with a new 3D camera module. This allows cost-effective 3D measurement and 2D inspection even for SMD manufacturers with small batch sizes.

The 3D·ViewZ camera module combines 3D measurement technology based on structured light with angled-view inspection from 360 possible angles, allowing maximum fault detection even in difficult-to-view component situations. The Basic Line·3D is an AOI system for manual and flexible loading of different circuit boards, making it particularly suitable for electronics manufacturers in the high mix/low volume sector.

Due to the flexible configuration variants (angled-view, rotary drive, PCB size) it can be specifically adapted to the respective requirements. A special added value of the system is the possibility of using the system for 3D solder paste inspection.

The MagicClick software tool provides significant time savings in the creation of AOI test programs. With no existing library entries, it generates a production-ready test program including component library within a few minutes. The assembly-specific layout is taken into account by importing and automatically analyzing CAD data. Parametrization and optimization is also fully automated and based on real process fluctuations. In total, the time saving for test program creation and optimization is up to 80%. Thus a return-on-investment is already possible after a short time

Share

Print


Suggested Items

Upgrading to a Digital Line

01/15/2020 | Nolan Johnson, I-Connect007
Ridhi Kantelal of Arch Systems breaks down what fabricators considering bringing in digitalization and upgrading their lines should know, and why they may see the most benefit from focusing on the data engineering aspect rather than the actual retrofitting of their systems.

BTU Discusses its Next-generation Flux Management System

12/18/2019 | Nolan Johnson, I-Connect007
At productronica 2019, Nolan Johnson spoke with Peter Franklin, managing director of BTU Europe, about BTU’s next-generation solder reflow flux management system—Aqua Scrub. A winner of the show’s Global Technology Award for Soldering, Peter breaks down the specifics of what makes Aqua Scrub such an intriguing technology.

A Walking Tour of Mycronic Equipment at productronica 2019

12/17/2019 | Real Time with...productronica
I-Connect007 pays a visit to the Mycronic booth at productronica 2019 in Munich, and Jeff Leal, product manager for Mysmart, takes us on a walking tour of just one of the lines on display at the show. Jeff takes us through a series of dispensing and conformal coating machines.



Copyright © 2020 I-Connect007. All rights reserved.