AIM Offers Training to Aptiv Employees


Reading time ( words)

AIM Solder to provide training to Aptiv employees on October 22, 2018 at Aptiv Rio Bravo I in Ciudad Juarez.

David Solis, technical application engineer, covered solder paste handling and the printing process during the on-site training session. Aptiv employees learned about storage, management and maintenance of solder paste to ensure consistent print results. David also shared information regarding printer parameters, stencil technologies, machine configuration and materials to allow engineers to maintain a high level of quality during the printing process.

With AIM’s success throughout the past 20 years in Mexico, its commitment to training and customer support continues to expand. Technical seminars, hosted in one of AIM’s facilities and on-site customer training are an integral part of this process globally.

AIM.jpg

Share

Print


Suggested Items

The Effectiveness of 75% IPA/25% DI Extraction Solution on No-clean Flux Residues

06/13/2019 | David Lober and Mike Bixenman, DBA, KYZEN; and Marietta Lemieux and Mark McMeen, STI
The continuous challenge in the electronics industry is to keep up with the demand for smaller, faster, and more reliable electronics. When it comes to cleaning, this rapid development of manufacturing and reliability challenges is juxtaposed with the slow pace of new test method development.

Reflow Your Solder and Your Data for Industry 4.0

06/11/2019 | Nolan Johnson, I-Connect007
I-Connect007 Managing Editor Nolan Johnson recently spoke with KIC President and Founder Phil Kazmierowicz and Manager of Applications and Sales MB “Marybeth” Allen as they each transitioned into new roles in the KIC leadership team. The conversation ultimately turned to the current dynamics in the industry, particularly Industry 4.0 and streamlining processes.

Laserssel Brings High-speed Soldering to New Application Areas

06/10/2019 | Barry Matties, I-Connect007
In this interview with I-Connect007, Denis Barbini, general manager of Laserssel, talks about the company's new laser-selective reflow solution aimed at reducing a typical reflow oven’s 10-minute cycle down to just 10 seconds as well as the overall benefits manufacturers could see from streamlining this process.



Copyright © 2019 I-Connect007. All rights reserved.