Lilotree’s Dr. Kunal Shah to Present at IPC APEX EXPO 2019


Reading time ( words)

LiloTree’s president and founder, Dr. Kunal Shah, will present a paper called “A Novel & Cost-effective Electroless Nickel Immersion Gold (ENIG) Surface Finish for Better Reliability of Electronic Assemblies” at IPC APEX EXPO 2019 at the San Diego Convention Center in San Diego, California. His presentation will be on Tuesday, January 29 at 3:30-5:00 p.m. in room 6D.

Dr. Shah will present his paper on his National Science Foundation award winning innovative new ENIG-Premium, a ground-breaking, world-changing innovation that provide better ENIG performance without cyanide. Because this product is about to be introduced to the general market, everyone interested in getting a much better performing ENIG (higher reliability) while getting the cyanide and saving up to 30% on gold usage should attend Dr. Shah’s presentation about ENIG-premium in San Diego next week.

Long-time industry expert, Steve Williams, has called ENIG-premium the most important technological innovation in the past twenty years. Commenting on the new product, Williams said, “After seeing the third-party test results, I am a true believer in ENIG-premium. It performs better than traditional ENIG, including allowing for a much more controlled gold plating so the average is 30% savings on gold usage and it gets rid of that nasty cyanide. This will be good for the PCB builders and ever better for the CEMs and OEMs who are using the boards.”

For those interested in a more in depth conversation about Lilotree’s ENIG-premium, they can meet with Dr. Shah and his entire team at their booth (booth # 243) as they will be exhibiting at the show as well. Also, there will be live demo of ENIG-premium plated boards and tight thickness distribution of gold thickness by on-site measurement using XRF.

About LiloTree

LiloTree is one of this country’s most innovative companies. They provide support and solutions for product improvements. Their team of scientists works cohesively to provide creative solutions to support and improve your company’s products. They provide support for all aspects of product development cycles from R&D, Manufacturing, Quality compliance, and failure analysis. They were awarded a National Science Foundation Grant for their development of ENIG-Premium.

Share

Print


Suggested Items

June Issue of SMT007: A Snapshot of a Resilient Industry

06/30/2020 | Tamara Jovanovic, Happiest Baby
Tamara Jovanovic, an electrical engineer at Happiest Baby in Los Angeles, never imagined that I would have to take half of my lab equipment home to be able to continue doing her job. As she says in her review of the June issue of SMT007 Magazine, the entire industry is adapting to the "new normal," and ready for whatever the future brings.

IPC’s Shawn Dubravac: COVID-19 Outbreak Accelerates Industry Shifts Already Under Way

05/21/2020 | Barry Matties, I-Connect007
On May 19, Barry Matties spoke with Shawn Dubravac, chief economist for IPC. While discussing other topics, Matties asked for Dubravac’s perspective on shifts in the market, who observed that the recessionary trend might be behind us; the markets are already showing recovery. Still, it could take a year or so to fully recover.

Happy’s Smart Factory Protocol Primer

04/29/2020 | Happy Holden, I-Connect007
The smart factory concept is built upon data interchange as the foundation. There has been much development in the area of industrial and manufacturing data protocols over the years, stretching back into the 1960s. This article by Happy Holden surveys what are considered the most common protocols in use in the electronics manufacturing industry today, including IPC-CFX/ Hermes, OML, SECS/GEM, and MAPS.



Copyright © 2020 I-Connect007. All rights reserved.