iNEMI Webinar on Next-Generation Solder Materials


Reading time ( words)

iNEMI will be holding a webinar on next-generation solder materials—a follow-up to the iNEMI workshop held at the recent IPC APEX EXPO 2019. This 30-minute session will give attendees an opportunity to briefly review the key points and outputs from the 70+ participants at the workshop.

The objective of this webinar is to prioritize the next steps in terms of projects and actions. Those interested in collaborating to address the challenges associated with deploying next-generation solder materials successfully in electronics manufacturing are encouraged to join this webinar.

The webinar is scheduled on March 12, 2019, 12:00 p.m. EDT (North America)/5:00 p.m. CET (Central Europe).

To register, click here.

Share

Print


Suggested Items

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

This Month in SMT007 Magazine: Test and Measurement in a Smart Factory

11/03/2020 | Nolan Johnson, I-Connect007
Nolan Johnson spoke with MIRTEC President Brian D’Amico about how the role of test and measurement equipment is changing in the smart factory and how shops can adjust to make use of the new technology. D’Amico shares this insight: “While approximately 90% of U.S. electronics manufacturers recognize the potential of Industry 4.0 to improve productivity, many are slow to adopt smart factory solutions within the manufacturing process.”

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2020 I-Connect007. All rights reserved.