Cascade Chapter of IPC Designers Council Meeting April 3


Reading time ( words)

The first quarterly IPC Designers Council Chapter Meeting for 2019 will be held April 3. There are a few changes this year that should make it easier for attendees to make it to the meetings.

The meetings will still be held at Lake Washington Institute of Technology-Kirkland Campus (LWIT) but the meetings have been moved back to an evening time slot. And there is no charge for this event, although donations are greatly appreciated.

This first chapter meeting will be on Wednesday April 3, 2019 from 6-8 pm in room A102. The topic for this meeting will be a roundtable discussion with three topics chosen based on feedback from our last survey. 

Discussion topics include:

  1. Cutting Edge Design techniques
  2. IPC Standards
  3. Materials and Processes

The Executive Board will be there to help guide and share their knowledge and experiences. The Executive Board has gathered over 100 years of experience combined, so attendees will be sure to learn something invaluable. Please join these great discussions and bring your experiences, ideas and knowledge on these topics.

Dinner is covered, so just sign up on the Cascade DC website and join your peers and co-workers.

To register, click here.

Chapter Meeting Dates for 2019

April 3
June 12
September 18
December 4

For more information, contact:

Tim Mullin, President
IPC Designers Council - Cascade Chapter
Website: http://cascade-ipcdc.org
Cell: (253) 229-6914

 

Share

Print


Suggested Items

Wild River, eSilicon, and Samtec Team up for 112-Gbps Test Vehicle

06/06/2019 | Andy Shaughnessy, Design007 Magazine
During DesignCon, I sat down for an interview with Tim Horel from eSilicon, Al Neves of Wild River Technology, and Matt Burns from Samtec. They’ve recently teamed up to create a 112-Gbps test vehicle that may be the first of its kind of test fixture.

Words of Advice for New PCB Designers

05/09/2019 | Andy Shaughnessy, Design007 Magazine
In a recent survey, we asked the following question: What do you think is the most important thing a designer should remember when planning a new PCB design? Here are a few answers, edited slightly for clarity. One favorite: "Have a good music selection."

EMA: Cadence Moves Simulation Further Up in the Design Cycle

03/15/2019 | Andy Shaughnessy, Design007 Magazine
Cadence Design Systems recently integrated more of its Sigrity capabilities into the front end of its PCB design tools. During DesignCon, Chris Banton of EMA Design Automation spoke with me about how this drive for “model-less analysis” benefits the PCB designer who can now access signal and power integrity, DFM, and electrical rule checking functionality early in the design process and have fewer issues later.



Copyright © 2019 I-Connect007. All rights reserved.