Rehm to Release Final Reflow Soldering Volume


Reading time ( words)

Rehm Thermal Systems will be launching the fifth and final volume in the book series “Reflow Technology—Fundamentals of Reflow Soldering” at the upcoming SMTconnect event in Nuremberg, Germany. Attendees will also have the opportunity to have their books signed on May 8, from 10:30 am onwards, by the authors Dr. Hans Bell, Günter Grossmann, Helmut Öttl and Martin Oppermann at Rehm’s stand (Hall 4A-100).

The fifth volume, titled "Possibilities and Limits in the Analysis of Solder Joints," explains many of the analytical processes and techniques used in the manufacture of electronic products in a straightforward manner. It should help many to understand which tool is best suited to which application and, ultimately, the significance of analytical results.

The first four volumes of this book series are as follows: "Fundamentals of Materials Technology in the Field of Soldering," "Reflow Soldering Methods," "Reliability and Failure Management," and "The Consequences of Continuous Miniaturization."

The books can also be ordered via email at sales@rehm-group.com. Volumes 1 to 4 cost €48 each, while the fifth volume costs €58.

Share

Print


Suggested Items

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

This Month in SMT007 Magazine: Test and Measurement in a Smart Factory

11/03/2020 | Nolan Johnson, I-Connect007
Nolan Johnson spoke with MIRTEC President Brian D’Amico about how the role of test and measurement equipment is changing in the smart factory and how shops can adjust to make use of the new technology. D’Amico shares this insight: “While approximately 90% of U.S. electronics manufacturers recognize the potential of Industry 4.0 to improve productivity, many are slow to adopt smart factory solutions within the manufacturing process.”

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2020 I-Connect007. All rights reserved.