Call for Participation: IPC Electronics Materials Forum 2019


Reading time ( words)

IPC invites you to present at the upcoming IPC Electronics Materials Forum which will be held November 5–7, 2019 in Minneapolis, Minnesota.

This new technical conference will focus on developments in materials and processes associated with advanced electronics assembly and manufacturing. Materials enable advancement because it is possible to envision many future technologies, but they will never be fully realized without the materials and processes to manufacture them.

The content will focus on materials for board fabrication, assembly, and post-assembly protection. The over-arching theme of emerging technologies that challenge our existing materials set will inform attendees on developments needed for the future. Interactive panels will also extend an open forum to discuss solutions to these challenges.

Seeking presentations on emerging technologies challenging existing material sets.

Other topics of interest include:

Substrate Materials:

  • Novel board laminates
  • Surface finishes
  • Solder mask advancements
  • Flexible/wearable circuits
  • HDI developments           

Assembly Materials:

  • New solder alloys
  • Flux development
  • Cleaning chemistries
  • Assembly process strategies
  • Thermal interface solutions            

Protective Materials:

  • Cleaning chemistries
  • Conformal coatings
  • Adhesives
  • Underfills

Who Should Attend?

Engineers and managers that procure materials or qualify materials, or want to understand advancements in materials for the board, assembly, components, and protective layers: Process Engineers, Manufacturing Managers, Materials Scientists, SMT Line Managers, Quality Managers (for materials or failure analysis).

 

Share

Print


Suggested Items

Part 12 of Siemens’ Digital Twin Webinar Series: MES and Enterprise Systems

11/25/2020 | I-Connect007 Editorial Team
I-007e Micro Webinars recently released a free, on-demand series titled “Implementing Digital Twin Best Practices From Design Through Manufacturing” with Siemens' Jay Gorajia. To conclude the series, in Part 12, Gorajia discusses, “Integrating Valor Solutions as Part of MES and Enterprise Systems."

Part 11 of Siemens’ Digital Twin Webinar Series: Data-Driven Manufacturing

11/18/2020 | I-Connect007 Editorial Team
I-007e Micro Webinars recently released a free, on-demand series titled “Implementing Digital Twin Best Practices From Design Through Manufacturing” with Siemens' Jay Gorajia. In Part 11, Gorajia discusses, “Data-Driven Manufacturing: Making Big Data Into Smart Data.”

Part 10 of Siemens’ Digital Twin Webinar Series: Inventory Management

11/11/2020 | I-Connect007 Editorial Team
I-007e Micro Webinars recently released a free, on-demand series titled “Implementing Digital Twin Best Practices From Design Through Manufacturing” with Siemens' Jay Gorajia. In Part 10, Gorajia looks at “Inventory Management in the Warehouse and on the Shop Floor.” Material accounts for 80% of PCB assembly costs. If not managed correctly, margins can be cut even further.



Copyright © 2020 I-Connect007. All rights reserved.