Murray Percival to Represent Ersa Advanced Soldering Solutions at SMTAI


Reading time ( words)

Murray Percival Company has announced that they will be available to demo the Ersa VERSAFLOW 3/45, HR550, i-CON VARIO 4 Station, and Ersa Mobile Scope at booth #424 at SMTA International, scheduled to take place September 24-25, 2019 at the Donald Stephens Convention Center in Rosemont, Illinois.

The Ersa VERSAFLOW 3/45 selective soldering system is based on a modular platform in order to satisfy all demands in regard to flexibility. Depending on the application and on the throughput requirements called for, additional flux, preheat and solder modules can be integrated into the system. In the maximum configuration level of the VERSAFLOW, the system can therefore operate with up to three solder modules, and each of these modules can again be configured with two mini-wave solder baths. In total, up to 6 mini-wave solder bath can be installed in a system, and each solder module can be preceded by a preheat unit.

Also at the show will be the HR 550 guided rework system, with a highly efficient 1500W hybrid heating head, highly accurate placement with integrated force sensor and large-area IR bottom heading in 3 zones. Also available for demos and education will be the i-CON VARIO 4 an electronically temperature-controlled multichannel soldering and desoldering station and the Ersa Mobile Scope. The Ersa Mobile Scope is a hand-operated inspection system for fast inspection of hidden solder joints.

Ersa Mobile Scope is available through Murray Percival in MI, OH, IN, KY, and W.PA.

About Murray Percival

Murray Percival Company is a third-generation family owned business that was founded in January of 1960. They are currently the leading supplier to the Midwest's electronics industry, offering thousands of capital and distribution products as well as the industry’s leading process enabler. www.murraypercival.com

Share

Print


Suggested Items

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

This Month in SMT007 Magazine: Test and Measurement in a Smart Factory

11/03/2020 | Nolan Johnson, I-Connect007
Nolan Johnson spoke with MIRTEC President Brian D’Amico about how the role of test and measurement equipment is changing in the smart factory and how shops can adjust to make use of the new technology. D’Amico shares this insight: “While approximately 90% of U.S. electronics manufacturers recognize the potential of Industry 4.0 to improve productivity, many are slow to adopt smart factory solutions within the manufacturing process.”

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2020 I-Connect007. All rights reserved.