Yamaha Motor Europe FA Launches SCARA Robot ‘YK400XE’


Reading time ( words)

Yamaha Motor Europe FA Section will release new SCARA robot “YK400 XE” (with an arm length of 400 mm) on September 17, 2019.

This “YK400XE” is a successor model of the conventional model “YK400XR” that features high accuracy and high performance even at a less expensive price. The maximum payload is 4 kg that is 1.4 times larger than the conventional model and the standard cycle time is reduced approx. 10% to achieve 0.41 sec. by strengthening the drive system and arm, increasing the rigidity, and improving the performance of the controller “RCX340.” As a result, the production capacity is much improved.

Even when the maximum payload is increased and the operating performance is improved, the high cost performance is achieved. In addition, as the installation position is fully compatible with the conventional model, the replacement work can be performed easily.

This product will be exhibited at Yamaha’s booth 7328 in hall 7 at Motek Show 2019 from 7th – 10th October 2019 in Stuttgart, Germany.

Share

Print


Suggested Items

Solder Mask Evolves into a Truly Additive Process

09/09/2019 | John Fix, Taiyo America Inc.
The 5G era is creating quite a bit of work for many PCB engineers as the materials required to keep up with the speed, frequency, and latency requirements need to be defined and qualified. Solder mask, for example, now becomes a truly additive process. Read on to find out how and why.

Selecting the Proper Flex Coverlayer Material

09/06/2019 | Dave Lackey, American Standard Circuits
Coverlayers are polymer materials used to cover and protect the copper traces of the flex circuit product. There are a number of different options available for protecting the circuits, and they serve different design requirements in terms of cost, performance, and flexural endurance optimization. When specifying the choice, it is critical to call out not just the type of coverlayer material but also the thickness requirement. This can be very important in certain types of constructions, especially when a flex circuit will experience dynamic flexing during use.

PCB Design Training: More Critical Than Ever

09/05/2019 | Andy Shaughnessy, Design007 Magazine
I interviewed Gary Ferrari of FTG at the IPC High-Reliability Forum and Microvia Summit in Baltimore. Gary is a co-founder of the IPC Designers Council and a longtime advocate for PCB design and PCB designers. We discussed the crucial role that PCB designers play in the entire electronics development process, and how IPC and the Designers Council are helping to educate and inform the next generation of designers.



Copyright © 2019 I-Connect007. All rights reserved.