BTU to Show the PYRAMAX Vacuum Reflow Oven and AQUA SCRUB Flux Management at IPC APEX EXPO


Reading time ( words)

BTU International, Inc., a leading supplier of advanced thermal processing equipment for the electronics manufacturing market, will exhibit at the 2020 IPC APEX EXPO, scheduled to take place Feb. 4-6, 2020, at the San Diego Convention Center in California. The team will showcase both the PYRAMAX™ Vacuum reflow oven and the AQUA SCRUB flux management in Booth #3119.

The PYRAMAX Vacuum reflow oven has been designed around requirements of large EMS/high-volume automotive customers. The unit is configured with 10 zones of closed-loop convection heating and a maximum production width of 18". Nitrogen atmosphere capable, the PYRAMAX Vacuum reflow oven offers a maximum process temperature of 350° C. In addition to full Industry 4.0 compliance, the vacuum reflow unit features automatic sequencing, programmable control of vacuum level and hold time and pass-through mode for non-vacuum operation.

The AQUA SCRUB flux management technology uses an aqueous-based rinse agent for most effective removal of flux from the oven’s process gas.  This system achieves truly hands-off maintenance by sequestering the flux waste into a removable jug. The AQUA SCRUB boasts a 4X reduction in cost of ownership and is field retrofit ready on PYRAMAX reflow ovens. 

Share

Print


Suggested Items

I-007e Micro Webinars Releases Part 2 in ‘Implementing Digital Twin’ Series

09/16/2020 | I-Connect007
I-007e Micro Webinars recently released a free, on-demand series titled “Implementing Digital Twin Best Practices From Design Through Manufacturing.” Each of the 12 segments can be viewed in about five minutes.

What Is Digital Twin Technology, and Why Is It So Important?

09/09/2020 | Happy Holden, I-Connect007
Happy Holden describes how Siemens' 12-part webinar series, “Implementing Digital Twin Best Practices From Design Through Manufacturing,” is an excellent series designed to educate the electronic manufacturing engineer on the progress of using a digital thread to improve products and performance.

This Month in SMT007 Magazine: Robustness Is Not the Same as Reliability

09/02/2020 | I-Connect007 Editorial Team
Bob Neves discusses a disconnect he sees in reliability testing between what’s being tested and what happens out in the field, as well as why most reliability tests these days should instead be considered robustness tests.



Copyright © 2020 I-Connect007. All rights reserved.