Thermaltronics Soldering Robots in Booth #437 at IPC APEX


Reading time ( words)

Thermaltronics USA, Inc. announces that it will exhibit at the 2020 IPC APEX EXPO, scheduled to take place Feb. 4-6, 2020 at the San Diego Convention Center in California. The company will demonstrate the TMT-R9900S Inline Robot Soldering System and TMT-2200S—“simultaneous” dual port operating solder station in Booth #437.

The Thermaltronics Robot, Model TMT-R9900S, functions as an inline or stand-alone production system and is equipped with full vision to verify the procedure being undertaken and does not simply follow a pre-determined program. In this respect it has an observation mode, a verification mode and as a result—a decision-making capability.

This equipment is autonomously capable of collecting and utilizing data for production processing, which is one of the most important factors necessary to meet the requirements of Industry 4.0 standards.

The TMT-2200S is based on Curie Heat Technology which responds to the thermal demands of each solder joint by adjusting the power instantaneously, thereby meeting the exact requirements of the substrate component and solder material. Maximum flexibility allows the use of K, P and S Series tips.

In addition to the hand soldering product line, Thermaltronics also provides an extended range of accessories to support both production and rework applications. Customers who wish to run free of charge trials on Thermaltronics hand soldering products are encouraged to contact info@thermaltronics.com. For more information, visit www.thermaltronics.com.

About Thermaltronics USA, Inc.

Thermaltronics is a manufacturer and supplier of a wide range of soldering products and accessories used in the electronics manufacturing industry. Design and development is undertaken in the USA and Australia, with final production taking place in a customized manufacturing facility, incorporating specialized equipment and in accordance with recognized international standards of quality and compliance.

Share

Print


Suggested Items

Clean vs. No-clean: A Generational Difference

12/24/2019 | Barry Matties, I-Connect007
Tom Forsythe, executive VP of KYZEN, discusses what readers should know about cleaning as reliability expectations continue to increase. He also explains what is driving the new interest in cleaning and why engineers from the no-clean generation may not even realize they need to learn more about cleaning.

UV-curable Materials and Conformal Coatings

12/23/2019 | Pete Starkey, I-Connect007
Pete Starkey and Phil Kinner, global business and technical director, coatings division, Electrolube, discuss the characteristics and benefits of the company’s new UV-cured conformal coatings. Phil also describes the development of coatings for critical avionics applications and Electrolube’s collaboration with the U.K. National Physical Laboratory to establish a new condensation test.

BTU Discusses its Next-generation Flux Management System

12/18/2019 | Nolan Johnson, I-Connect007
At productronica 2019, Nolan Johnson spoke with Peter Franklin, managing director of BTU Europe, about BTU’s next-generation solder reflow flux management system—Aqua Scrub. A winner of the show’s Global Technology Award for Soldering, Peter breaks down the specifics of what makes Aqua Scrub such an intriguing technology.



Copyright © 2020 I-Connect007. All rights reserved.