GOEPEL electronic Presents New Series of Affordable 3D AOI Systems


Reading time ( words)

Large and small electronics manufacturers are subject to relentless demands for reduced cost and improve quality. To meet these demands the GOEPEL electronic has launched two new Automatic Optical Inspection Systems. The 3D XE series of AOI platforms are characterised by low acquisition costs whilst still delivering full 3D inspection functionality.

The series consists of the stand-alone system Basic Line · 3D XE and the inline system Advanced Line · 3D XE. Flexible interfaces such as Hermes or PULSE allow production line integration of the inline version; for smaller quantities, the offline 3D AOI system with manual loading is an attractive solution. In addition, both systems can be used as full 3D solder paste inspection systems (SPI). Thus configuration as an inspection island offers a highly efficient and flexible production environment. (especially for the Advanced Line · 3D XE).

3D XE series platforms are controlled using the latest PILOT AOI software and MagicClick for AI-based, fully automatic creation and optimization of inspection programs. This functionality enables the system to inspect new assemblies within a few minutes and without any component library. For manufacturing service providers with a large variety of products this is especially important. It guarantees a high degree of cost-effective use even for the smallest of board quantities and saves up to 80% of program creation and optimization time.

Share

Print


Suggested Items

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

This Month in SMT007 Magazine: Test and Measurement in a Smart Factory

11/03/2020 | Nolan Johnson, I-Connect007
Nolan Johnson spoke with MIRTEC President Brian D’Amico about how the role of test and measurement equipment is changing in the smart factory and how shops can adjust to make use of the new technology. D’Amico shares this insight: “While approximately 90% of U.S. electronics manufacturers recognize the potential of Industry 4.0 to improve productivity, many are slow to adopt smart factory solutions within the manufacturing process.”

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2020 I-Connect007. All rights reserved.