AIM’s Flopy Feng to Present at SMTA China South Technical Conference


Reading time ( words)

AIM Solder, a leading global manufacturer of solder assembly materials for the electronics industry, is pleased to announce that Flopy Feng will present at the 2020 SMTA China South Technology Conference at the Shenzhen Convention & Exhibition Center in Shenzen, China. Flopy’s presentation, “Pin-In-Paste,” is scheduled for August 26th, 2020 from 11:05-11:40.

The presentation will detail the Pin-in-Paste (PiP) process including PCB and stencil design considerations as well as solder paste selection and reflow guidelines. The PiP technique can be more cost effective by eliminating the need for a wave or selective soldering process and the associated costs. Learn more on www.aimsolder.com.

Flopy Feng is a technical support manager for AIM Solder. Having worked as a process supervisor for seven years, he is experienced in process evaluation and optimization. With over 15 years’ of experience in the SMT industry, Flopy supports AIM customers in south China.

Share

Print


Suggested Items

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

This Month in SMT007 Magazine: Test and Measurement in a Smart Factory

11/03/2020 | Nolan Johnson, I-Connect007
Nolan Johnson spoke with MIRTEC President Brian D’Amico about how the role of test and measurement equipment is changing in the smart factory and how shops can adjust to make use of the new technology. D’Amico shares this insight: “While approximately 90% of U.S. electronics manufacturers recognize the potential of Industry 4.0 to improve productivity, many are slow to adopt smart factory solutions within the manufacturing process.”

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2020 I-Connect007. All rights reserved.