Just Ask Eric: Selecting the Right Lead-Free Solder for Your Application


Reading time ( words)

First, we asked you to send in your questions for Happy Holden and Joe Fjelstad in our “Just Ask” series. Now, it’s Eric Camden’s turn! A regular SMT007 columnist, Eric is a lead investigator at Foresite Inc., an analytical testing and consulting laboratory. As a reliability expert, Eric has worked with many large OEMs and contract manufacturing companies to optimize their manufacturing processes and assist with the identification of electronic hardware failures utilizing various analytical techniques. He also specializes in optimizing PCBA processes and identifying hardware failures through analysis. We hope you enjoy “Just Ask Eric.”

Q: How can I pick out the right lead-free solder for my application?

A: That’s a great question. It’s one I regularly get regarding choosing solder and other process materials. As with most questions like this one, the first answer is always, “It depends.” It depends on variables, such as end-use operating environment, expected life cycle, which IPC product class you need to build to, etc.

You can refer to the IPC J-STD-001 and the related test methods in the TM-650 for determining acceptance criteria like hole-fill, circumferential wetting, etc., but all those requirements are just a start. You may also need to consider additional testing above and beyond what is in the IPC documents or even on the print.

Depending on the operating environment, you might need to consider extended vibration testing or thermal cycling to determine if the solder candidate is a good option. One of the most important things to consider is the ability of your equipment to process it.

At the risk of painting with a broad brush, almost any solder will probably work, but you must be sure you know how to set your equipment parameters to yield a reliable solder joint. If you use cross-section to determine the quality of the solder joint, you need to know how to make parameter adjustments to correct any issues you might be seeing. Picking the solder is really only one part of the equation.

To submit your questions to Eric Camden, click here.

Share

Print


Suggested Items

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

This Month in SMT007 Magazine: Test and Measurement in a Smart Factory

11/03/2020 | Nolan Johnson, I-Connect007
Nolan Johnson spoke with MIRTEC President Brian D’Amico about how the role of test and measurement equipment is changing in the smart factory and how shops can adjust to make use of the new technology. D’Amico shares this insight: “While approximately 90% of U.S. electronics manufacturers recognize the potential of Industry 4.0 to improve productivity, many are slow to adopt smart factory solutions within the manufacturing process.”

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2020 I-Connect007. All rights reserved.