Insituware to Award Six $100 Amazon Gift Cards during SMTAI


Reading time ( words)

Insituware LLC, the developer of the first smart measurement solution for quality control of materials, is giving away six $100 Amazon gift cards during their live demos at the SMTA International virtual event.

Each day of the show (September 28, 29, and 30), Insituware will host live demos in their virtual booth to showcase the Vision MARK-1, a revolutionary hand-held tool that can help you detect and diagnose defects in solder paste within minutes right on the shop floor, reducing costly mistakes and preventing manufacturing delays.

The demos will be at 10AM EST (9AM CST) and 2PM EST (1PM CST) each day. During each live demo, the presenter will say a key word. Attendees can then ‘enter’ the drawing by going to www.insituware.com/contact and filling out the contact form with the subject line “SMTAI Amazon Gift Card” and writing the key word in the body of the email.

The lucky winners will be contacted when the SMTA International virtual event has concluded.

To read more about the SMTA International virtual event and register for free as an attendee, visit smta.org.

Insituware is revolutionizing the way we control materials quality in electronics manufacturing! For more information, visit insituware.com.

About Insituware LLC
Insituware is an innovative technology company developing novel products to measure materials in the electronics manufacturing industry. Driven by advanced analytical sensors, smart devices, and intelligent cloud-based information, these revolutionary hand-held tools enable rapid, real-time inspection to improve material quality control, increase efficiency, and lower cost.

To learn more about Insituware, check out their Real Time with...SMTAI 2020 Interview.

Share

Print


Suggested Items

This Month in SMT007 Magazine—Continuous Improvement: As Simple as X = Xc – 1

01/04/2021 | I-Connect007 Editorial Team
X=Xc – 1 is a conceptual equation for continuous improvement. You define X and work to reduce it by a factor of 1. This could be one work hour, one process step, one day less in a cycle, and so on. We recently met with Dr. Ron Lasky to discuss the concept of X=Xc – 1 and get his advice on generating enthusiasm among readers and the next generation about continuous improvement. As this discussion illustrates, many process improvements are small in scale, not yearlong, major efforts.

Top 10 Most-Read SMT Articles of 2020

12/31/2020 | I-Connect007
As 2020 comes to a close, the I-Connect007 Editorial Team takes a look back at its most read articles. Here are the top 10 reads in SMT from the past year.

SMTA Europe Solder Finish Webinar Addresses Defects Causes and Cures

12/14/2020 | Pete Starkey, I-Connect007
“What is your most common PCB problem?” A survey conducted by Bob Willis had revealed finish solderability to be the predominant contender, and it was clear that the choice of solderable finish applied to surface mount boards could have a significant effect on the assembly yield and cost of the final circuit. SMTA Europe organised an informative and enlightening webinar this month entitled “Guide to PCB Solder Finishes—Process Defects Causes and Cures,” with soldering specialist Bob Willis as presenter.



Copyright © 2021 I-Connect007. All rights reserved.