The IPC STEM Event Inspires


Reading time ( words)

Once again, IPC APEX EXPO featured its successful STEM event, organized by the IPC Education Foundation, and sponsored by several companies, including I-Connect007. The event had nearly 80 students in person for a hands-on introduction to our industry. After the welcoming comments, the students broke into groups for different activities. While some enjoyed a guided tour of the show floor, upstairs the other students learned how to solder. Then they rotated so that they all had the same opportunities.

These students, many of whom were having their first exposure to the world of electronics, kept focused on the task in front of them—solder a small circuit board that would make a connection for two LEDs to illuminate on the opposite side of the board.

Students sat four to a table, a hot soldering iron next to them, a paper full of instructions, and a chance for some true hands-on learning. As the students worked, volunteer IPC committee members and Emerging Engineers roamed around, helping students where needed and remembering back to their own first experiences in the industry.

Of course, when you set several people at table to complete the task it can quickly turn into a fun competition. We caught up with two students who did just that. (See the video below)

Though this a STEM introduction event, we learned that several of the students we talked to had little intention of pursuing a career in electronics, nonetheless the exposure to the industry demonstrated that possible careers are much larger than they may have imagined before attending the IPC APEX EXPO event.

When asked about their career paths, here are some of their responses:

  • I want to be film director
  • I’m looking for nursing
  • Marine biology
  • A career in the film industry
  • Probably a STEM field
  • Owning a business, having my own business
  • I don’t know, but something in the music industry hopefully
  • Apprenticeship, electrician

During the event we also interviewed one of the teachers, Melissa Woods, who brought her students to this event and past events. She expressed her desire to continue bringing students to the event because it broadens their horizons and demonstrates new opportunities. Her interview follows.

To read this entire article, which appeared in the Real Time with… IPC APEX EXPO 2022 Show & Tell Magazine, click here.

Share




Suggested Items

Mining for Metals Requires a Long View

06/15/2022 | Nolan Johnson, I-Connect007
Nolan Johnson talks with Shaun Dykes, a 50-year expert in the mining industry. Dykes gives a concise primer on mining development, and the amount of time and effort required to develop and supply the mineral resources we depend upon for the manufacture of printed circuit boards. There are many factors that play into when and where a mine is developed—and what can prevent a mine from ever producing minerals.

Book Excerpt: 'The Printed Circuit Assembler’s Guide to… Solder Defects'

06/07/2022 | I-Connect007 Editorial Team
Solder defects in surface-mount technology (SMT) assembly have been an issue for decades. Further, the combined challenges of Pb-free soldering and ever-increasing miniaturization have resulted in new or exacerbated defects in electronics assembly, but there are proven ways to avoid defects. This book will be especially beneficial to PCB assemblers in improving their assembly processes and the reliability of the end-product, eliminating field failures, and reducing costs.

VJ Electronix: Automating the X-ray Inspection Process

05/04/2022 | Nolan Johnson, I-Connect007
VJ Electronix's Brennan Caissie shares the benefits of a new inspection tool that can be used on a variety of boards, with an automated system that takes the pressure off the manufacturing floor operators and can provide feedback all the way to the design process.



Copyright © 2022 I-Connect007. All rights reserved.