iNEMI’s End-of-Project Webinar: Extended Reliability Assessment for Electronic Components


Reading time ( words)

Failure of electronic components can be a catastrophic occurrence, or at least a very costly one. When a component fails, it impacts the whole system. The importance of having reliable components becomes even more critical for applications such as medical equipment, automotive, or aerospace and defense.

The main objective of iNEMI’s Extended Reliability Assessment for Electronics Components project is to identify and develop a set of extended reliability assessment methods for electronic components/PCB assemblies used in critical applications and harsh environments. The team is focused on proposing test methodologies or sequences that will accelerate failure detection of faulty components and enable verification cycles to be shortened and improved, saving both time and cost.

Phase 1 of the project identified component-level parts that would be the most valuable to a range of users in the electronics industry. The team considered several possible testing scenarios for these components based on potential use conditions and began identifying ways to conduct testing for extended reliability.

Join iNEMI for this project report-out which will review Phase 1 findings and recommendations as well as identify next steps for Phase 2. 

Registration

This webinar is open to industry; advance registration is required (see iNEMI's website). 

Session 1: Thursday, October 27
11:00 a.m. — 12:00 p.m. EDT (US)
5:00-6:00 p.m. CEST (Europe)
 
Session 2: Friday, October 28
11:00 a.m. — 12:00 p.m. CST (China)
8:00-9:00 p.m. PDT (US) on October 27

Share




Suggested Items

It’s an Exciting Time in Electronics

10/06/2022 | Sal Sparacino, SMTA
SMTA International is just around the corner, and we are excited to be meeting fully in person and onsite. The conference and expo runs from Monday, Oct. 31 through Thursday, Nov. 3, returning to the Minneapolis Convention Center. Once again, we will co-locate with Medical Design & Manufacturing Minneapolis 2022 (MD&M). As the world continues to adjust to the new normal following nearly years of the pandemic, an in-person industry conference and exhibition is more valuable than ever.

Exploring High Density With Axiom

05/06/2022 | I-Connect007 Editorial Team
Nolan Johnson and Barry Matties talk with Axiom’s Rob Rowland and Kevin Bennett about the current high-density challenges facing EMS manufacturing. In this interview, Bennett and Rowland zero in on component packaging and feeder technology as critical areas in need of improvement.

The Reality of Regulated Manufacturing

04/12/2022 | Nolan Johnson, I-Connect007
Nolan Johnson speaks with Ryan Bonner, CEO of DEFCERT, about government regulations for data and cybersecurity. A key component of moving to a digital factory will be to ensure security of the data required to operate a digital factory, and most importantly, customer design data.



Copyright © 2022 I-Connect007 | IPC Publishing Group Inc. All rights reserved.