Intertronics Launches Opti-tec 5013


Reading time ( words)

Opti-tec 5013 high performance, two-part epoxy from Intertronics is a water white clear general adhesive for bonding glass, ceramics, plastics and metals as well as some optical and opto-electronic applications. It ensures strong, clear structural bonds, including for repair and restoration where aesthetics are a priority. It can also be used for small volume potting and encapsulation.

Opti-tec 5013’s medium viscosity provides good gap filling characteristics, whilst its high surface energy enables wetting and wicking between surfaces – before and during the cure cycle. At room temperature, handling strength is achieved in 30 minutes, with full cure time taking just two hours. This can be accelerated to ten minutes at 65°C.

Opti-tec 5013 is supplied in convenient side-by-side double cartridges.

Share

Print


Suggested Items

Minimizing Voids in Solder Joints

06/07/2019 | Rehm Thermal Systems
Dr. Hans Bell of Rehm Thermal Systems, Henryk Maschotta of Thales Deutschland GmbH, and Dr. Heinz Wohlrabe of TU Dresden presented the results of their project on reducing void content in the solder joints of land grid arrays (LGAs) at a soldering seminar during the Technology Days of the recent SMTconnect show in Nuremberg.

Most Important Feedback

01/09/2019 | Stephen Las Marias, I-Connect007
In our recent I-Connect007 survey, we asked the following question: “What is the most important feedback that you receive after your board is manufactured?” Here are just a few of the replies, edited slightly for clarity.

Top Five BGA Challenges to Overcome

10/09/2017 | Bob Wettermann, BEST Inc.
Higher reflow temperatures of lead-free rework increases the pressure for properly shielding the neighboring components. These developments are causing BGA rework challenges. This summary will discuss the most challenging aspects of BGA rework and options for solutions.



Copyright © 2020 I-Connect007. All rights reserved.