RTW IPC APEX EXPO: ACE's Alan Cable Discusses Benefits of Selective Soldering, and Need for Lead Tinning


Reading time ( words)

Alan Cable, president of ACE Production Technologies, talks to I-Connect007 guest editor Mark Thompson about selective soldering and how it helps electronics assemblers overcome the high cost of labor.

He also discusses the need for lead tinning, especially in high-reliability markets and applications such as military and aerospace.

Watch The Interview Here

Share

Print


Suggested Items

The Role of Parylene Conformal Coatings in Next-gen Electronics

08/19/2019 | Tim Seifert, Specialty Coating Systems
Designers and manufacturers of electronics are under pressure to make packages smaller, lighter, and more environmentally friendly, while ensuring that their new technologies perform reliably in their operating environments. This article takes a closer look at Parylene conformal coatings and the role they can play in helping manufacturers address current and future challenges in the electronics industry.

Names to Know: Up and Comers in U.S. Congress

08/14/2019 | Ken Schramko, IPC Senior Director, North American Government Relations
When major news occurs in the U.S. Congress, you usually hear the names of top congressional leaders such as House Speaker Nancy Pelosi (D-CA) or Senate Majority Leader Mitch McConnell (R-KY).

Approaches to Overcome Nodules and Scratches on Wire-Bondable Plating on PCBs

07/17/2019 | Young K. Song and Vanja Bukva, Teledyne Dalsa Inc., and Ryan Wong, FTG Circuits
Initially adopted internal specifications for acceptance of printed circuit boards (PCBs) used for wire bonding was that there were no nodules or scratches allowed on the wirebond pads when inspected under 20X magnification. This paper details if wire bonding could be successfully performed over nodules and scratches and if there was a dimensional threshold where wire bonding could be successful.



Copyright © 2019 I-Connect007. All rights reserved.