July 2019 Issue of SMT007 Magazine Out Now


Reading time ( words)

It should come as no surprise that solder and solder joints are often at the center of attention in electronics assembly when discussing failures and reliability. Enter "Reliability Man," the hero who must persevere against all the challenges thrown in his path. Find out in the July 2019 issue of SMT007 Magazine.

This month’s issue of SMT007 Magazine is now on the virtual newsstand, and available for delivery in your e-mailbox by subscribing here.

Share

Print


Suggested Items

Book Excerpt: The Printed Circuit Assembler’s Guide to Process Validation

12/24/2020 | Graham Naisbitt, Gen3 Systems
It is assumed that readers are familiar with manufacturing electronic circuit assemblies in accordance with IPC-J-STD-001 or IEC 61189-1; both are titled “Requirements for Soldered Electrical and Electronic Assemblies.” In October 2018, IPC-J-STD-001 Revision G was amended and released with a new Section 8 of the document titled “Cleaning.” The change was primarily the removal of a “cleanliness” level of 1.56 mg/square cm of NaCl equivalence. This small change has great significance in relation to how companies ensure the electrochemical reliability of their products.

Real Time with… SMTAI 2020: Reflections on the Technical Conference

10/07/2020 | Real Time with...SMTAI
This year’s SMTA International Conference and Exposition went virtual! Pete Starkey explains how the SMTA team did a fine job in difficult circumstances to present an interactive show and technical conference. Here, he highlights four of the papers that particularly caught his interest.

This Month in SMT007 Magazine: Robustness Is Not the Same as Reliability

09/02/2020 | I-Connect007 Editorial Team
Bob Neves discusses a disconnect he sees in reliability testing between what’s being tested and what happens out in the field, as well as why most reliability tests these days should instead be considered robustness tests.



Copyright © 2021 I-Connect007. All rights reserved.