SMTA California Chapters Present 'Technology Day'


Reading time ( words)

The three California SMTA Chapters (San Diego, Los Angeles/Orange County, and Silicon Valley) are proud to present “SMTA California Technology Day.”

This live virtual event will feature three non-commercial technical presentations covering:

  1. X-ray: "The X-factor: How X-ray Inspection Improves the Manufacturing Process" (Dr. Bill Cardoso of Creative Electron)
  2. Failure Analysis: "Understanding Where Contamination Comes From and the Effect On Reliability" (Eric Camden of Foresite)
  3. Stencil Printing: "Stencil Printing of 008004 (imperial)/0201 (metric) Aperture Components" (Edward Nauss of ITW/EAE/MPM)

In addition to the three technical presentations, there will also be messages from all three California SMTA chapter officers and a message from the new SMTA President (Dr. Martin Anselm) on the new initiatives from SMTA. During the entire event, you will be able to chat in real time with the speakers, SMTA chapter officers, and the SMTA Board of Directors as well as with each other.

The SMTA California Technology Day will take place on Tuesday, December 8 from 9:00 AM - 12:00 PM (PST).

Participation in this event only requires a browser. Absolutely no downloaded software is required.

This event is open to all. The event is free to SMTA members and non-members. More information and registration is available at smta.org.

Share

Print


Suggested Items

Catching Up With Nova Engineering

04/27/2021 | Dan Beaulieu, D.B. Management Group
When searching for companies to interview, I always look for something unique and that makes the company special. Truth be told, I am a collector of stories about good, well-run, unique companies that we can learn something from. Nova Engineering is one of those companies.

What Makes a Good Process Engineer?

03/03/2021 | Nolan Johnson, I-Connect007
Nolan Johnson recently spoke with Tuan Tran, director of customer solutions at Green Circuits, about what makes a successful process engineer. They also discuss a typical day in the life of a process engineer—from pre-manufacturing through post-DFM, for process improvement. As Tuan points out, there are a variety of paths to becoming a great process engineer.

Tech 2 Tech: KYZEN’s Short Technical Sessions a Big Hit

01/20/2021 | Nolan Johnson, I-Connect007
Nolan Johnson gets an update from Tom Forsythe on KYZEN’s Tech 2 Tech sessions. These brief 15-minute sessions were set up during the pandemic by KYZEN for customers, prospects, and new engineers around cleaning, and have since found traction with their manufacturers, reps and distributors.



Copyright © 2021 I-Connect007. All rights reserved.