Virtual Industries Offers Versatile STEALTH-VAC ELITE Vacuum Pen


Reading time ( words)

Virtual Industries Inc., a leading supplier of manual vacuum handling solutions, offers the STEALTH-VAC™ ELITE ESD-SAFE Kit – Normally Closed VACUUM PEN™ (Order #VVSV-NC-KIT). The system operates on compressed air or nitrogen. 

The STEALTH-VAC™ ELITE operates directly on 30 to 50 psi filtered compressed air or nitrogen. The normally closed STEALTH-VAC™ ELITE VACUUM PEN™ contains a whisper quiet venturi vacuum generator that is activated only when the control button is depressed. This helps conserve factory compressed air when the tool is not in use. 

The vacuum level can be controlled by adjusting the input pressure. At 10 psi input the vacuum level is 2 InHg with 1 lpm of free air flow, at 30 psi input the vacuum level is 10 InHg with 3 lpm of free air flow, and at 70 psi input the vacuum level is 20 InHg with 4 lpm of free air flow. 

The STEALTH-VAC ELITE comes with five bent probes mounted with Non-marking Buna-N Static Dissipative Non-Marking Vacuum Cup sizes 3/32” (2.38mm), 1/8” (3.18mm), 3/16” (4.76mm), 1/4” (6.35mm), and 3/8” (9.53mm), as well as four straight probes mounted with Non-marking Buna-N Static Dissipative Non-Marking Vacuum Cup sizes 1/8” (3.18mm), 1/4” (6.35mm), 3/8” (9.53mm) and 1/2” (12.70mm). Also included is the vacuum hose with an adaptor and a stand to rest the handle in when not in use.

Share

Print


Suggested Items

Super Dry: Increasing Component Storage Needs

03/03/2021 | Nolan Johnson, I-Connect007
Nolan Johnson speaks with Super Dry’s Richard Heimsch about how the need for dry storage solutions has increased throughout the pandemic, including further demands for traceability and automation capabilities.

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2021 I-Connect007. All rights reserved.