Creative Materials Introduces Series of isotropic, Anisotropic B-stage Electrically Conductive Adhesive Films


Reading time ( words)

Creative Materials introduces a series of isotropic and anisotropic B-stage electrically conductive adhesive films. The controlled reflow and high reliability of these adhesive films sets them apart from most other adhesive films. Both series of products are available in sheets and as custom preforms to customer-specified geometries. 125-22-F is an isotropically conductive series of films available in standard thicknesses of 1-5 mils; other thicknesses can be requested. 126-37-F is an anisotropically conductive series of films and is recommended for use at 1 or 2 mil thicknesses. Another version of 126-37-F accommodates atypical bond-line thicknesses and contact pitches. All of these films and preforms are supplied on an easy-to-remove release liner.

These products offer excellent thermal stability and high temperature properties to 325ºF, excellent electrical conductivity, chemical resistance when fully cured, adhesion to a wide variety of high-energy surfaces, minimal flow during bonding and curing, and low CTE. Cure temperatures as low as 100ºC can be used.

Both products are typically used in conductive splicing of ribbon cables, PTF circuits, electrical attachment of surface-mounted devices as well as assembly of electrical and electronic components. The anisotropic product is used when shorts between closely spaced contacts is a concern. 

Creative Materials designs, develops, and custom manufactures specialty electronic inks and adhesives. The company holds both ISO9001 and ISO14001 certifications. All products are manufactured in the USA.

Share

Print


Suggested Items

Northrop Grumman: 3D Nanomaterials May Counter Gaps in Additive Supply Chain

10/22/2020 | Andy Shaughnessy, Design007 Magazine
The best technology is dead in the water if your domestic supply chain won’t support it. That was just one of the takeaways from Dr. Judy Dickson’s talk during the SMTA Additive Electronics TechXchange. In her presentation, titled “Advanced PWBs: A Collaboration Between Design, Operations, and the Supply Chain,” Dickson, a senior principal systems engineer at Northrop Grumman Mission Systems, laid out the many challenges her department faces in fielding HDI advanced packaging into the next decade. Most of these challenges are related to sourcing the necessary materials in the U.S.

Increase Traceability, Prevent Counterfeiting

08/25/2020 | I-Connect007 Editorial Team
Michael Ford, senior director of emerging industry strategy for Aegis Software and I-Connect007 columnist, speaks about the increasing importance of traceability in manufacturing and throughout the supply chain, including how it affects such areas as counterfeit components and inventory management.

The iNEMI 2019 Board Assembly Roadmap

06/01/2020 | Pete Starkey, I-Connect007
iNEMI continues to publish chapters of its 2019 Roadmap and recently presented an overview of its Board Assembly Roadmap Chapter in a webinar prefaced by Grace O’Malley, vice president of global operations. The new chapter is just the latest addition to this global effort from 23 working groups contributing expert input from all aspects of the electronics industry.



Copyright © 2021 I-Connect007. All rights reserved.