productronica 2015: Transition Automation Talks about Improving Paste Print Quality for New Markets


Reading time ( words)

Mark Curtin, president of Transition Automation explains the finer points of metal squeegee blades to I-Connect007’s Stephen Las Marias. The improved print quality has proved significant to meet the reliability challenges of high power electronics as well as the increased precision required for newer automotive electronics requirements.  Take a close-up look at them in this video.

Watch the interview here.

Share

Print


Suggested Items

Book Excerpt: The Printed Circuit Assembler’s Guide to Process Validation

12/24/2020 | Graham Naisbitt, Gen3 Systems
It is assumed that readers are familiar with manufacturing electronic circuit assemblies in accordance with IPC-J-STD-001 or IEC 61189-1; both are titled “Requirements for Soldered Electrical and Electronic Assemblies.” In October 2018, IPC-J-STD-001 Revision G was amended and released with a new Section 8 of the document titled “Cleaning.” The change was primarily the removal of a “cleanliness” level of 1.56 mg/square cm of NaCl equivalence. This small change has great significance in relation to how companies ensure the electrochemical reliability of their products.

Real Time with… SMTAI 2020: Reflections on the Technical Conference

10/07/2020 | Real Time with...SMTAI
This year’s SMTA International Conference and Exposition went virtual! Pete Starkey explains how the SMTA team did a fine job in difficult circumstances to present an interactive show and technical conference. Here, he highlights four of the papers that particularly caught his interest.

This Month in SMT007 Magazine: Robustness Is Not the Same as Reliability

09/02/2020 | I-Connect007 Editorial Team
Bob Neves discusses a disconnect he sees in reliability testing between what’s being tested and what happens out in the field, as well as why most reliability tests these days should instead be considered robustness tests.



Copyright © 2021 I-Connect007. All rights reserved.