iNEMI to Hold Webinar on Assessment of Lead-Free Solder Joint Reliability


Reading time ( words)

The accelerated testing typically done by industry can be very deceptive unless the results can be counted on to somehow reflect performance in service. As far as lead-free solder joints are concerned, this is more often an issue than commonly recognized. In general, reliability engineers need to know when “best in test” is unlikely to mean “best in service,” how large deviations may be, and which comparisons can be counted on to be conservative.

Binghamton University has recently completed a mechanistically justified model for the thermal fatigue of lead-free solder joints which allows for the generalization of observed trends. Even if not used to predict actual life in service, this model leads to recommendations for test protocols and guidelines.

iNEMI will be holding a research webinar on September 28, 2016, at 11:00 a.m. EDT (North America)/5:00 p.m. CEST (Central Europe), that will review some of the leading issues related to testing lead-free solder joints and discuss the Binghamton University model.

The webinar will be conducted by Dr. Peter Borgesen, Professor of Systems Science & Industrial Engineering and a member of the Materials Science program at Binghamton University. His research focuses on the assessment and optimization of reliability.

This webinar is open to members and non-members, and registration is free.  For more information and to register, click here.

Share

Print


Suggested Items

Benchmarking Your Process Engineering

04/29/2021 | I-Connect007 Editorial Team
Mark Thompson has been in bare board fabrication for over 30 years. He is now laying out printed circuit boards at Monsoon Solutions, a high-tech design bureau near Seattle, Washington. With Mark’s extensive hands-on knowledge of PCB manufacturing, he brings a unique perspective to PCB design. In this discussion with the I-Connect007 editorial team, Mark shares what’s important from a process engineer’s point of view, and how to stay on top of evaluating and benchmarking your manufacturing process, along with insights from his new role as a designer.

EIPC Technical Snapshot: 5G and Loss Minimisation

03/26/2021 | Pete Starkey, I-Connect007
Bringing a specialised technical area into sharp focus, this month’s topic was “5G and the understanding of loss minimisation at the PCB level,” with papers on dielectric material, copper foil, and modelling solutions. The webinar was moderated by EIPC board member Paul Waldner managing director of Multiline International Europa, who admitted that he had managed to get a haircut especially for the occasion!

PCB Requirements for E-Mobility

03/23/2021 | I-Connect007 Editorial Team
Nolan Johnson, Barry Matties, and Happy Holden speak with Christian Klein, section manager for PCBs in the automotive electronics division, about Bosch’s recent presentation on PCB requirements of the future in regard to automotive and electro mobility trends and challenges.



Copyright © 2021 I-Connect007. All rights reserved.