Real Time with...IPC: BEST Talks Rework Challenges and Opportunities


Reading time ( words)

Bob Wettermann, president of BEST Inc., talks with I-Connect007's Stephen Las Marias about the challenges in rework, and how his company is helping their customers address these problems. He also discusses his paper presentation at this week's technical conference.

Watch The Interview Here

Share


Suggested Items

DFM: Top Ten PCB Concerns

07/09/2018 | Dan Thau, Millennium Circuits Ltd
DFM—design for manufacturability—is a critically important but often ignored aspect of the PCB design process that directly impacts product quality and reliability. This article will discuss the top 10 DFM concerns that should be part of any design review process.

Tackling the Challenges in Flex Assembly

07/06/2018 | Stephen Las Marias, I-Connect007
Apart from the design and manufacturing of flex printed circuits, a critical challenge that needs attention is assembly. Their flexible nature requires specific strategies for paste printing, chip mounting, soldering—whether reflow, wave, or hand—and rework/repair processes. Which is why the June 2018 issue of SMT007 Magazine looks into the many challenges in flex circuit assembly and highlight some of the strategies, techniques and best practices to help assemblers deal with flex circuit issues.

West Penn SMTA: New Leadership, Same Commitment

06/28/2018 | Patty Goldman, I-Connect007
SMTA's new chapter president, Jason Emes, a quality engineer with Pennatronics Corporation enthusiastically discussed with I-Connect007's Patty Goldman the latest goings-on with this Keystone State chapter. He also spoke about his plans and initiatives for the SMTA West Penn Chapter.



Copyright © 2018 I-Connect007. All rights reserved.