STI Electronics to Exhibit at SMTA International


Reading time ( words)

STI Electronics, Inc, will exhibit in Booth #818 at SMTA International, scheduled to take place September 19-20, 2017 at the Donald Stephens Convention Center in Rosemont, IL. STI company representatives will discuss the company’s Training Resources and Engineering Services divisions.

An IPC authorized training center for J-STD-001, IPC-A-610, IPC/WHMA-A-620, IPC-A-600 and IPC-7711/7721, STI provides both Certified IPC Application Specialist (CIS) and Certified IPC Trainer (CIT) courses. STI’s Training Services division develops customized training courses to fit specific training needs. Typically, STI builds these classes around company-specific standards and specifications.

Other courses include basic soldering, wave soldering, ESD training, BGA rework and many more. It also provides operator/inspector training for through-hole and SMT soldering, conformal coating, and training to the requirements of NASA-STD-8739.1 and NASA-STD-8739.4 for Marshall Space Flight Center and its support contractors. In addition to its standardized training program support materials, STI Electronics’ Training Materials division provides unique or custom training materials including Fine Pitch Lead Free Solder Training Kits. STI is an approved distributor for IPC training materials.

From product design and manufacturability analysis to pre-production prototype and development, STI’s Prototype and Development Lab is a full-service design review and preproduction facility. STI’s Microelectronics Lab was established to meet the rising need for advanced systems development and assembly. STI's Engineering Services division provides engineering support and specialized contract manufacturing services for the electronics manufacturing industry.

The Microelectronics Lab specializes in state-of-the-art engineering design including current technologies such as Chip-On-Board (COB) and Multichip Module (MCM) as well as emerging technologies such as Imbedded Component/Die Technology (IC/DT).

About STI Electronics, Inc.

Since 1982, STI Electronics, Inc. (STI) has been the premier full service organization for training, consulting, laboratory analysis, prototyping, and small-to-medium volume PCB assembly in the electronics industry. STI also produces a complete line of solder training kits and training support products. For more information, click here.

Share


Suggested Items

PCB Pad Repair Techniques

01/08/2018 | Bob Wettermann, BEST Inc.
There are a variety of reasons behind pads getting "lifted" completely or partially from the laminate of a PCB. Per the just revised IPC-A-610 Revision G, a defect for all three classes occurs when the land is lifted up one or more pad thicknesses. Lifted pads can occur when a device has been improperly removed or there is a manufacturing defect in the board construction. In any case, as with any repair, the ultimate decision on the ability to repair the pad lies with the customer.

Top 10 Most-Read SMT007 Columns of 2017

01/02/2018 | I-Connect007
Another year is over in the SMT industry. 2017 saw a myriad of hot topics, including Industry 4.0, the millennials’ entry into the manufacturing space, and alternative solder materials, to name a few. Without further ado, here are the Top 10 columns from SMT007 over the past year.

The Effect of Area Shape and Area Ratio on Solder Paste Printing Performance

12/28/2017 | Stefan Härter, et al.
The ongoing miniaturization trend in the SMT production induces new challenges and highly integrated systems. In passive components, the miniaturization leads to the introduction of the EIA size 01005 or smaller. Despite numerous publications in this field already addressing the printing of such devices, a defined wholly optimized process remains unsolved and inspires further novel research ideas on this topic.



Copyright © 2018 I-Connect007. All rights reserved.