Multitest Launches Pick-and-Place Handler Option


Reading time ( words)

The Multitest MT2168 pick-and-place handler now offers a ground fault monitoring option. The ground fault monitoring option is part of a feature set that will enhance the value of the production output at the customer site. Ground fault monitoring is an important feature for meeting advanced quality standards.

The ground fault monitoring option is a continuous self-check of the MT2168 to detect grounding issues which may result in pre-damaged devices. Without this option grounding issues may only be detected during regular preventive maintenance, but no information can be obtained such as when the issue actually started and which test lots may be affected. With increasing quality standards ground fault monitoring is considered a mandatory at many production floors.

The ground fault monitoring option can be retrofitted in the field.

About Multitest

Multitest (headquartered in Rosenheim, Germany) is one of the world’s leading manufacturers of semiconductor material handling equipment and interfaces for the testing and calibration of semiconductors and sensors. Multitest markets a broad portfolio of innovative and performance driven test handlers, contactors and ATE printed circuit boards. Multitest has more than 30 years of experience in the semiconductor industry, providing solutions to the automotive, consumer, communication, and sensor markets. Multitest is a company of Xcerra Corporation, which provides capital equipment, interface products, and services to the semiconductor, industrial, and electronics manufacturing industries. Xcerra Corporation offers a comprehensive portfolio of solutions and technologies, and a global network of strategically deployed applications and support resources. Additional information can be found at here and here.

Share


Suggested Items

RTW IPC APEX EXPO: Miraco Company and Services Introduction

03/29/2018 | Real Time with...IPC
Miraco's current quality manager, William Pfingston, fills Guest Editor Steve Williams in on the company's contract manufacturing capabilities and services, including strengths in design and flex circuits. He also talks about the company's expansion and organizational changes.

Why You Want Your EMS Partner to Be Annoying and Boring

01/04/2018 | Neil Sharp, JJS Manufacturing
Outsourcing part or all of your manufacturing to an electronics manufacturing service (EMS) provider can be daunting. Handing over some of the control of your business can be a scary prospect.

Should I Involve My EMS Partner in DFM?

10/26/2017 | Neil Sharp, JJS Manufacturing
OEMs are seeking the support of EMS providers with more than just manufacturing, but with design elements too. One of the main design services EMS providers will be likely to offer is design for manufacture (DFM). This article highlights why engaging your EMS partner in DFM is worthwhile, and will be valuable in securing the longevity of your product.



Copyright © 2018 I-Connect007. All rights reserved.