CyberOptics Showcases All-in-One Relative Humidity, Leveling and Vibration Measurement Sensor for Reticle Environments at SPIE


Reading time ( words)

CyberOptics Corporation will demonstrate its ReticleSense Auto Multi Sensor (AMSR) – the world’s most efficient and effective wireless measurement devices for semiconductor fabs and equipment OEMs at the SPIE PhotoMask Technology and EUV Lithography conference, September 17-20 at the Monterey Conference Center in California in booth #104.

ReticleSense Auto Multi Sensors (AMSR) measure leveling, vibration, and relative humidity (RH) in an all-in-one wireless real-time device. The AMSR speeds equipment qualification, shortens equipment maintenance cycles and lowers equipment maintenance expenses. Multiple measurements can be captured and monitored in all locations of the reticle environment, saving equipment engineers or process engineers’ time and expense.

CyberOptics will also demonstrate the ReticleSense Airborne Particle Sensor (APSRQ) that speeds equipment set-up and long-term yields in semiconductor fabs by wirelessly monitoring airborne particles in real-time. Engineers can save time by swiftly locating contamination sources and see the effect of cleanings, adjustments and repairs.

About CyberOptics

CyberOptics Corporation (www.cyberoptics.com) is a leading global developer and manufacturer of high precision sensing technology solutions. CyberOptics’ sensors are used in SMT, semiconductor and metrology markets to significantly improve yields and productivity. By leveraging its leading edge technologies, the company has strategically established itself as a global leader in high precision 3D sensors, allowing CyberOptics to further increase its penetration of key vertical markets. Headquartered in Minneapolis, Minnesota, CyberOptics conducts worldwide operations through its facilities in North America, Asia and Europe.

Share

Print


Suggested Items

Flex Circuit Supply Chain Challenges

02/13/2019 | Stephen Las Marias, I-Connect007
In our recent Flex and Rigid-Flex survey, we asked the following question: "Do you have problems with your flex circuit supply chain?" Below are just a few of the explanations of those who answered "Yes", slightly edited for clarity.

RTW IPC APEX EXPO 2019: Electrolube Discusses Overcoming Secondary Cure Issues

02/13/2019 | Real Time with...IPC
Phil Kinner, technical director of Electrolube's coatings division, speaks with I-Connect007 Technical Editor Pete Starkey about how secondary cure issues with UV conformal coatings have been overcome and shows some typical examples.

RTW IPC APEX EXPO 2019: MacDermid Alpha Discusses New Materials to Improve Void Issues

01/30/2019 | Real Time with...IPC
Traian Cucu, Ph.D., G.A.T.E Group Leader at MacDermid Alpha Electronics Solutions, discusses with I-Connect007 Managing Editor Nolan Johnson some of the methods to reduce, or eliminate, the solder voiding issue, especially with the continuing trend towards lower-pitch, high-density components.



Copyright © 2019 I-Connect007. All rights reserved.