Electrovert and Zestron to Host Joint Inline Cleaning Workshop


Reading time ( words)

ITW EAE will be demonstrating its Electrovert Inline cleaning equipment at a joint workshop hosted by Electrovert and Zestron. The workshop will take place October 11-12 at Zestron’s Technical Center in Ingolstadt, Germany. Participants will have a unique opportunity to learn first-hand from cleaning technology experts and observe the entire cleaning process and cleanliness evaluation. The event will offer an exchange of knowledge and networking with others who have similar cleaning challenges.

Zestron will provide practical training on analytical methods for surface evaluation and walk through the decision procedure for selecting the best cleaning media and equipment combination. A guest speaker from Etek will also be available to discuss process management concerns such as water treatment regulations and the influence of contaminations by metals, salts and organics.

“We will have hands on demonstrations of inline cleaning machines for high and low volumes,” said Greg Calvo, ITW EAE Electrovert product manager. “We will look at the mechanics for cleaning low stand-off components and then demonstrate the process and look at the results under a microscope.”

Further details on this workshop including a complete agenda and online registration is available here.

Share

Print


Suggested Items

DSG: Breaking Ground on the Smart Factory Revolution

04/17/2019 | Barry Matties, I-Connect007
Mauro Dallora leads the I-Connect007 team through the Dongguan Somacis Graphic (DSG) PCB Co. Ltd. facility in China, lays out the company’s strategy for becoming an Industry 4.0 smart factory, and explains the current ongoing major expansion. Read about various topics in this factory tour and interview.

Bill Cardoso Discusses Creative Electron’s Inspection Strategy

04/03/2019 | Tim Haag and Barry Matties, I-Connect007
At PCB West in Santa Clara, California, Dr. Bill Cardoso of Creative Electron held a class on advanced packaging and X-ray inspection strategy. Guest Editor Tim Haag and Publisher Barry Matties met with Bill to further discuss his class and the importance of turning inspection data into information.

Tips & Tricks: Wave Solder Bridging

04/03/2019 | Jason Fullerton, MacDermid Alpha Electronics Solutions
Wave solder bridging is the most difficult defect to troubleshoot because it has a number of potential causes. The key is to understand the role of flux during wave contact—thus reducing the surface tension of the solder to reduce the tendency to bridge between pins as the board leaves the wave.



Copyright © 2019 I-Connect007. All rights reserved.