Landrex Technologies Mourns Loss of CEO and Founder Steve Hsu


Reading time ( words)

Landrex Technologies, a manufacturer of printed circuit assembly test and inspection products, has lost company founder and CEO Steve Hsu after an extended illness. His untimely death was announced by Jim Gibson, president of Landrex operations in North America and Europe.  Mr. Hsu was 53 years old and had launched Landrex in 1989 with two partners who both remain with the company.

Replacing him as CEO is Kent Lien a long time executive under Hsu. He is expected to continue the practices and strategies that have brought Landrex to prominence in the very competitive test fixture business as well as with the automated optical inspection(AOI) equipment used to inspect PCBAs. The position of board chairperson will be assumed by Janice Hsu.  Funeral services are planned for December 30, 2018 at 10:00 a.m. in New Taipei City, Taiwan. 

Share

Print


Suggested Items

Impact of Stencil Foil Type on Solder Paste Transfer Efficiency for Laser-cut SMT Stencils (Part 1)

04/24/2019 | Greg Smith, BlueRing Stencils
As innovation and demand continue to drive miniaturization in electronics, manufacturers face the constant challenge of assembling smaller and smaller components with repeatable processes and high yields. Stencil printing is the first step in the PWB assembly process, and improvements to the SMT stencil can significantly improve yields, especially for more challenging miniaturized products.

Mentor and Seica Partner for Data Prep and Testing Big Boards

01/18/2019 | Pete Starkey, I-Connect007
Mark Laing, business development manager of the Valor division at Mentor, a Siemens company, and Luca Corli, director of sales at Seica, speaks with I-Connect007 Technical Editor Pete Starkey about the partnership between their two companies, which enables efficient data preparation for testing big boards, and accelerates new product introduction (NPI) cycles.

Solder Paste Selection/Qualification

01/16/2019 | Stephen Las Marias, I-Connect007
In a recent SMT007 survey, we asked the following question: " What are your challenges when it comes to solder paste selection/qualification?" Here are just a few of the replies, slightly edited for clarity.



Copyright © 2019 I-Connect007. All rights reserved.