Goepel Webinar on Reliable Automatic Optical Inspection of Selective Solder Joints


Reading time ( words)

The automatic optical inspection of solder joints after the selective soldering process is increasingly becoming the focus of process optimization. Regardless of whether the solder joints are realized using induction, laser or piston soldering processes or miniature waves, the quality of the selective solder joints must be evaluated automatically and reliably.

In line with this, Goepel electronic will be holding a webinar that will provide an overview of the integration of camera modules for 2D and 3D selective solder joint inspection in different production environments. During the presentation, attendees will learn more about the requirements for such integration solutions and how the technical details of the hardware and software of the camera modules are derived from them. In addition, the concepts for connecting the inspection solution to company-internal MES or traceability systems will be discussed.

The webinar, to be held on April 29, 2019 at 10am CDT (3pm UTC, 5pm MESZ), will be presented by David Whetstone, director of North American Sales Engineering at Goepel electronic.

For more information or to register, click here.

Share

Print


Suggested Items

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

This Month in SMT007 Magazine: Test and Measurement in a Smart Factory

11/03/2020 | Nolan Johnson, I-Connect007
Nolan Johnson spoke with MIRTEC President Brian D’Amico about how the role of test and measurement equipment is changing in the smart factory and how shops can adjust to make use of the new technology. D’Amico shares this insight: “While approximately 90% of U.S. electronics manufacturers recognize the potential of Industry 4.0 to improve productivity, many are slow to adopt smart factory solutions within the manufacturing process.”

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2020 I-Connect007. All rights reserved.