ZESTRON’s Ravi Parthasarathy to Present at SMTA Capital Expo


Reading time ( words)

ZESTRON's solutions in the electronics manufacturing and semiconductor industries, is pleased to announce that Ravi Parthasarthy will be presenting “Jet Printed Solder Paste and Cleaning Challenges” at the SMTA Capital Expo on August 22.

Presentation Abstract:

Recent evidence has shown that it is becoming extremely challenging to consistently deliver the correct amount of solder using the screen printing process. More and more manufacturers in today’s production environment are overcoming this challenge by incorporating jet printing as an additional step to increase solder paste volume. Solder paste jetting offers the flexibility to deposit the right volume of solder paste on boards with both miniature and large components that must be soldered adjacent to each other.

Anecdotal evidence indicates that as solder powder becomes finer, the resulting flux residues become more difficult to remove. This presentation is part of a study executed specifically on jet printing (Type 5) solder pastes using multiple cleaning agents in both spray-in-air inline and batch cleaning systems. The results are further validated by several industry case studies.

Along with Parthasarathy’s presentation, ZESTRON will have an exhibit at SMTA Capital event. Please visit us in the expo area to discuss cleaning solutions applicable to your electronics engineering or manufacturing process.

About ZESTRON

ZESTRON is headquartered in Manassas, Virginia and operates in more than 35 countries. With eight technical centers worldwide and the industry’s most knowledgeable team of engineers focused on high precision cleaning, ZESTRON’s commitment to ensuring that its customers surpass even the most stringent cleaning requirements is without equal.

For additional information or to tour one of our technical centers, please visit www.zestron.com.

Share

Print


Suggested Items

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

This Month in SMT007 Magazine: Test and Measurement in a Smart Factory

11/03/2020 | Nolan Johnson, I-Connect007
Nolan Johnson spoke with MIRTEC President Brian D’Amico about how the role of test and measurement equipment is changing in the smart factory and how shops can adjust to make use of the new technology. D’Amico shares this insight: “While approximately 90% of U.S. electronics manufacturers recognize the potential of Industry 4.0 to improve productivity, many are slow to adopt smart factory solutions within the manufacturing process.”

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2020 I-Connect007. All rights reserved.