Nordson ASYMTEK's Application Engineers Will Discuss Dispensing for Advanced Packaging at SEMICON Taiwan


Reading time ( words)

Nordson ASYMTEK, a Nordson company, will highlight fluid dispensing systems, applications, processes, and best practices for advanced packaging assembly at the D-Tek Technology booth #I2312-First Floor, at SEMICON Taiwan 2019, Taipei Nangang Exhibition Center, Taipei, Taiwan, September 18-20, 2019. 

"Fluid dispensing processes have become more critical for back-end semiconductor applications, especially those that involve high-speed or small-volume dispensing, tight keep-out zones, or dispensing of thin and accurate lines," said Garrett Wong, product manager for Nordson ASYMTEK. "Nordson ASYMTEK is constantly refining its dispensing systems to evolve with marketplace demands, precisely dispensing into the tightest places, at remarkable speeds, without compromising accuracy."

Live demos will be available of ASYMTEK's Vantage® Series with the IntelliJet® Jetting System that delivers cutting-edge reliability and micro-dot jetting with up to 1,000 Hz frequency. The Vantage system's fine-line dispensing capabilities meet requirements for underfill, gap fill, sealing lines for fan-out/fan-in, strips, and module assembly.

About Nordson ASYMTEK

Nordson ASYMTEK, a world leader in precision fluid dispensing, conformal coating, and jetting technologies, designs and manufactures dispensing and coating systems, supported by an award-winning global applications and service network for over 35 years. To find out more, visit www.NordsonASYMTEK.com, or on social media.

About Nordson Corporation

Nordson Corporation is one of the world's leading producers of precision dispensing equipment that applies adhesives, sealants, coatings, and other materials to a broad range of consumer and industrial products during manufacturing operations. The company also manufactures equipment used in the testing and inspection of electronic components as well as technology-based systems for curing and surface treatment processes. Headquartered in Westlake, Ohio, Nordson has direct operations and sales support offices in more than 30 countries.

Share

Print


Suggested Items

How Do I Get Smart With IPC CFX? (Part 1)

07/30/2019 | Michael Ford, Aegis Software Corp.
Today's assembly factories are seeing the biggest challenge to face the industry in a generation, called by many the next industrial revolution. However, in essence, the challenge is a simple extrapolation of trends that have been occurring and increasing in assembly manufacturing for decades. In Part 1 of this two-part article, Michael Ford writes about the history behind the drive for automation in the SMT assembly industry and where CFX fits in.

A Not So Surprising Focus for Flex in the XR Realm

03/14/2018 | Dan Feinberg
Dan Feinberg has been covering augmented, virtual, and mixed-reality for I-Connect007 for the last few years. He recently met with Eric Braddom, VP of Extended Reality (XR) Product Management for Flex, a company that is involved in this disruptive technology. In this interview, Dan and Eric discuss the future of augmented, mixed and/or virtual reality, or as Flex calls it, "extended reality."

Solder Ball Joint Reliability with Electroless Ni/Pd/Au Plating – Influence of Electroless Pd Plating Film Thickness

06/20/2017 | Yoshinori Ejiri, et al., Hitachi Chemical Co. Ltd
This paper investigated the influence of Pd film thickness in electroless Ni/Pd/Au plating on the solder ball joint reliability. It was found out that the shape and thickness of the intermetallic compounds (IMCs) are among the key factors that affect solder joint reliability after multiple reflow cycles and thermal aging, respectively.



Copyright © 2019 I-Connect007. All rights reserved.