PDR to Show Compact X-ray Systems at APEX


Reading time ( words)

PDR, a leading manufacturer of BGA rework systems, test, and inspection equipment since 1985, is pleased to announce plans to exhibit its X-ray equipment at the 2020 IPC APEX EXPO, scheduled to take place Feb. 4-6, 2020 at the San Diego Convention Center in California. The company will display the GenX-90P and GenX-130P High Powered Performance, Compact X-ray Systems in Booth #1213.

The GenX-90P and GenX-130P offer truly remarkable image clarity with proprietary HD camera and software. The compact systems accommodate PCB sizes up to 21” (533mm) X 17.5” (445mm). Customizable Flat Panel Detectors or Image Intensifier options are available to meet varying application requirements. Additionally, the high performance X-ray systems offer programmable 4-axis (X,Y, Z 1/Z2) fully motorized motion control.

The GenX-90P features a 90kV, 8 Watt, 4um X-ray tube, 0.18mA with magnification up to 1100X. The GenX-130P features a 130kV, 16W, 5um to 6um X-ray tube, 0.18mA with magnification up to 665X.

Made in America, all X-ray systems exceed both North American and European standards for safety as well as providing factory personnel with software to analyze BGAs, QFNs, bond wire sweep, gull wing joint analysis, offset drill measurement, or custom analysis algorithms tailored to customer needs. Motion control can be automated and coupled with a library of custom algorithms to provide very low-cost semi-automated PCB or part inspection. Systems can be ordered with either a traditional image intensifier or high-resolution flat panel detector.

PDR Rework Systems remains at the forefront of rework technology by providing air nozzle free systems with advanced in-process control features and visible light that takes the guesswork out of rework. PDR X-ray Solutions was founded in 2012, distributing and supporting X-ray Solutions for industry under the PDR Brand as well as other well-known X-ray Brands.

Share

Print


Suggested Items

June Issue of SMT007: A Snapshot of a Resilient Industry

06/30/2020 | Tamara Jovanovic, Happiest Baby
Tamara Jovanovic, an electrical engineer at Happiest Baby in Los Angeles, never imagined that I would have to take half of my lab equipment home to be able to continue doing her job. As she says in her review of the June issue of SMT007 Magazine, the entire industry is adapting to the "new normal," and ready for whatever the future brings.

IPC’s Shawn Dubravac: COVID-19 Outbreak Accelerates Industry Shifts Already Under Way

05/21/2020 | Barry Matties, I-Connect007
On May 19, Barry Matties spoke with Shawn Dubravac, chief economist for IPC. While discussing other topics, Matties asked for Dubravac’s perspective on shifts in the market, who observed that the recessionary trend might be behind us; the markets are already showing recovery. Still, it could take a year or so to fully recover.

Happy’s Smart Factory Protocol Primer

04/29/2020 | Happy Holden, I-Connect007
The smart factory concept is built upon data interchange as the foundation. There has been much development in the area of industrial and manufacturing data protocols over the years, stretching back into the 1960s. This article by Happy Holden surveys what are considered the most common protocols in use in the electronics manufacturing industry today, including IPC-CFX/ Hermes, OML, SECS/GEM, and MAPS.



Copyright © 2020 I-Connect007. All rights reserved.