GE Aviation Purchases Hentec/RPS Pulsar Solderability Test System


Reading time ( words)

Hentec Industries/RPS Automation, a leading manufacturer of selective soldering, lead tinning and solderability test equipment, is pleased to announce that GE Aviation has purchased a Pulsar solderability system. 

The Pulsar utilizes the highly proven dip-and-look test method that is a qualitative type test performed by comparative analysis after specimens are dipped in a bath of flux and molten solder. 

An advantage of the dip-and-look method is since it is based on comparative analysis it can be performed rapidly by shop floor personnel with minimal training as well as requiring significantly lower capital investment then a wetting balance test system.  

The Pulsar solderability test system complies with all applicable solderability test standards including MIL-STD-883 Method 2003, IPC J-STD-002 and MIL-STD-202 Method 208. 

Share




Suggested Items

Mining for Metals Requires a Long View

06/15/2022 | Nolan Johnson, I-Connect007
Nolan Johnson talks with Shaun Dykes, a 50-year expert in the mining industry. Dykes gives a concise primer on mining development, and the amount of time and effort required to develop and supply the mineral resources we depend upon for the manufacture of printed circuit boards. There are many factors that play into when and where a mine is developed—and what can prevent a mine from ever producing minerals.

Book Excerpt: 'The Printed Circuit Assembler’s Guide to… Solder Defects'

06/07/2022 | I-Connect007 Editorial Team
Solder defects in surface-mount technology (SMT) assembly have been an issue for decades. Further, the combined challenges of Pb-free soldering and ever-increasing miniaturization have resulted in new or exacerbated defects in electronics assembly, but there are proven ways to avoid defects. This book will be especially beneficial to PCB assemblers in improving their assembly processes and the reliability of the end-product, eliminating field failures, and reducing costs.

VJ Electronix: Automating the X-ray Inspection Process

05/04/2022 | Nolan Johnson, I-Connect007
VJ Electronix's Brennan Caissie shares the benefits of a new inspection tool that can be used on a variety of boards, with an automated system that takes the pressure off the manufacturing floor operators and can provide feedback all the way to the design process.



Copyright © 2022 I-Connect007. All rights reserved.